EN
Accusplit logo
Official user manual

Accusplit Pedometer (1020)

1 pages·601 KB·Fitness Electronics·PDF·ENDEFRITNLJA
Accusplit Pedometer (1020)
Table of Contents 6 sections ACCUSPLIT® EAGLE ™ 1020 · OPERATING INSTRUCTIONS · STEPS · ACCUSPLIT EAGLE 1020 · … ShowHide
Page 1 of the Accusplit Pedometer (1020) user manual — NO-PROOF-OF-PURCHASE LIMITED WARRANTY
Page 1 · click to enlarge
Page 1

ACCUSPLIT® EAGLE ™ 1020

OPERATING INSTRUCTIONS

Congratulations on taking the first step to wellness with your purchase of an

ACCUSPLIT pedometer. It’s easy to set up your new pedometer.

Just follow the steps below, and start walking!

WEARING YOUR PEDOMETER While gently holding the belt clip open, slide the pedometer onto your belt or the top edge of your pants or skirt. It should fit snugly and level, above one knee. Note: The pedometer should be as vertical as possible. Walkers with larger stomachs may find it helpful to wear the pedometer farther back on the body, toward one hip. To avoid losing or dropping your pedometer, use the included leash and clip to fasten the pedometer securely to your clothing.

STEPS

ACCUSPLIT EAGLE 1020

Attaching the Leash: Attach the pedometer to the leash by looping the leash around the pedometer belt clip. Next, clasp the waist-band of your clothing with the attached clip. You can also use a safety pin to fasten the leash to your clothing, loop the leash through your belt or belt loop or use a badge holder.

RESET

RESETTING YOUR PEDOMETER Most people prefer to reset step counts daily. To reset: Press RESET button to reset to zero.

Accusplit Pedometer (1020) — RESET diagram (page 1)
Fig. 1

First, loop the pedometer clip

REPLACING THE BATTERY When the display starts to dim or goes blank, it is time to replace the battery. Your pedometer uses one Type L1142 (LR43) 1.5 volt silver oxide battery. To replace:

Next, loop the metal clip, then clasp clothing

1. Using a jeweler’s screwdriver or fingernail, gently pry battery cover from case, using slot at top of cover.
2. Pull the old battery gently out of its holder. Replace it with a new battery. The battery’s positive (+) terminal should be FACE UP while you put it into the pedometer.
3. Slide bottom of battery cover back into place, then snap top of cover back into place.

Or, loop a badge holder, then

not included) Or, loop a belt or belt loop

NO-PROOF-OF-PURCHASE LIMITED WARRANTY

VIEWING YOUR RESULTS Once you put on your pedometer, it will automatically begin to record your steps.

See label on back of unit for details, or check

http://support.ACCUSPLIT.com

REGISTER NOW Please return your AE1020 Registration to the Repair Center address in the warranty, and we will let you know about future products.

  • ACCUSPLIT, Inc.
  • 3090 Independence Drive, Suite 148
  • Livermore, CA 94551 USA 800-935-1996
  • 925-290-1900
  • FAX 925-290-1930
  • <a href="http://www.ACCUSPLIT.com" rel="nofollow noopener" target="_blank">www.ACCUSPLIT.com</a>
  • support@<a href="http://ACCUSPLIT.com" rel="nofollow noopener" target="_blank">ACCUSPLIT.com</a>
Show 5 more labels / short text on this page
put into pocket · (Badge holder · Email (preferred) · User · 970-060
Sources

References & links

Pages referenced in this manual — manufacturer, support and downloads.

Ask about the Accusplit Pedometer (1020)

Owners and our team usually reply within a day — and your question helps the next person too.

Add your email to get notified when it’s answered — no spam, ever.

0 questions
No questions yet about the Accusplit Pedometer (1020)

Be the first to ask — other owners or our team will answer.

Original document

Accusplit Pedometer (1020) manual PDF

1 pages·601 KB·Fitness Electronics·PDF
Click any page above to open it here
Page 1 / …
100%
Loading pages…