Instruction/ maintenance manual of the product 8450 Series Coleman
Go to page of 28
Gas Barbecue Use, Car e & Assembly Manual W ith Grill Lighting Instructions 8450 Series Model No. 9992-649 (Natural Gas) ASSEMBLER/INST ALLER: Leave these instructions with the consumer . CONSUMER/USER: Read all instructions and keep in a safe place for future r eference.
2 DANGER • FOR OUTDOOR USE ON L Y . NEVER operate grill in enclosed areas, as this could lead to gas accumulating from a leak, causing an e xplosion or a carbon monoxide buildup which could result in injur y or death. DO NO T use in garages, breez ewa ys, sheds or any enclosed area.
3 • Installation must conf or m with local codes or , in the absence of local codes, with either the National Fuel Gas Code , ANSI Z223.1 (USA), Natur al Gas and Propane Installation Code, CSA B149.1 (Canada), or Propane Stor age and Handling Code, CSA B149.
4 Longer detachable po wer-supply cords or extension cords m ust be used with care. The marked electrical rating of the cord set or e xtension cord must be at least as great as the electrical rating of the appliance. If the appliance is of the grounded type , the e xtension cord should be a grounding-type 3-wire cord.
5 Grill Features — 8450 Series 12 1. Grill Hood 2. Ther mometer 3. Hood Handle 4. Side Bur ners 5. Control Knobs: Side Bur ners 6. Electronic Igniter : Right Main Bur ners and Side Bur ners 7. Drip T ra ys 8. Conv ection V ents 9. Control Knobs: Main Bur ners 10.
Replacement Parts List — 8450 Series 6 Gr ill Gas Con v ersion Kit (not sho wn) 9992-269 8450 Series NG to LP Conv ersion Kit Gr ill Rotisser ie Kit (not sho wn) 9992-557 8450 Series Gr ill.
7 PLANNING AND DESIGN Star t by identifying the n umber and size of components you w ant to include in your outdoor cooking center . Counter tops must be constructed of non-combustib le, outdoor-saf e mater ials. Consider outdoor lighting to illuminate after-dark grilling.
8 Built-In Instructions — 8450 Series 27 1/2” Minimum A 57 3/8" B 25 1/8" C 13" Minimum clearance to open hood 5” Open space 1.50” 0.75” Max Max 1.440 Max T op V iew 0.75 Note: Make Sure T o Use Non-Combustible Material For Construction Additional Requirements: • If using a backsplash apron or rear wall, locate electrical service on the left hand side for rotisserie motor construction.
Natural Gas Installation — 8450 Series NO TE: Y our 8450 Series grill is set up from the f actor y to use NA TURAL GAS. If you w ant to use LP GAS, y ou must purchase the LP GAS CONVERSION KIT (sold separately). Please skip to the section titled “ LP Cylinder Con version - 8450 Series ” .
IMPORT ANT : Remove all pr otective plastic film from stainless steel parts prior to assembly/use. This film is installed at the factory to prevent damage that could occur during shipment and handling. Grill Assembly — 8450 Series Fig. 5 1. Inser t the row of six heat tents with the triangle r idges f acing up (Fig.
Grill Assembly — 8450 Series 1. Install the burners and caps (Fig. 6 and Fig. 7). Fig. 6 Fig. 7 Fig. 8 2. Install the grate o ver the b ur ners (Fig. 8). Side Burner Installation Fig. 9 Igniter Battery Installation 1. The AA batter y , spring and igniter cap must be installed before using (Fig.
IMPOR T ANT! T O ENSURE PROPER GAS FLO W , BURNER CONTROL V AL VES MUST BE “OFF” BEFORE OPENING THE GAS CYLINDER V AL VE . W ARNING: During assembl y of the grill and when attaching or replacing the L.P . gas cylinder , insure that the gas supply hose is free of kinks and/or damage and is at least 3 inches a way fr om hot surfaces such as the grill casting.
Liquefied P etroleum gas (abbre viated L.P . gas or propane), is highly flammable . It becomes liquid when stored under high pressure inside a cylinder and vaporizes when released. L.P . gas is heavier than air and tends to collect in lo w areas.
14 CAUTION Hav e the gas dealer weigh the cylinder after filling to ensure that the cylinder is not ov er filled. The pressure regulator and hose assembly with the T ype 1 fitting supplied with the appliance must be used. Do not use another hose and regulator assembly other than the one supplied with the grill or a Coleman® replacement pressure regulator assembly .
15 A. Hose end valv e with a bleed port (Fig. 17): Purging can be accomplished using a hose end valv e containing a bleed port which also allows for e vacuation without the use of an adapter . B. Hose end v alve without a b leed por t: When a hose end valv e does not hav e a bleed por t, a separate de vice must be used for e vacuation.
16 DANGER T O P REVENT F IRE OR E XPLOSION H AZARD : • NO SMOKING. DO NOT use or permit sources of ignition in the area while doing a leak test. • P erform leak tests outdoors only . • NEVER perform a leak test with fire or flame. Leak T esting • If you detect a leak: 1.
1. Regular ly check the b ur ner venturi tubes f or bloc kage from an insect nest. Read “Cleaning the V enturi” in the section titled “Care, Maintenance, and Cleaning”, and also the section titled “T roubleshooting”. 2. Check that all the b ur ner venturi [H] are set ov er the valv e outlets [J] correctly .
Lighting Main Burners Lighting Side Burner 1. Push and turn the side bur ner control knob countercloc kwise to the “HIGH” position. (Fig. 28) 2. Immediately press and hold the electronic igniter button (Fig. 28). Y ou will hear a snapping sound.
19 Using the Rotisserie — 8450 Series The grill rotisserie system is designed to cook items from the back using infrared heat. The rotisser ie b ur ner is an infrared type which provides intense searing radiant heat. Preferred b y chefs ov er other cooking methods, this intense heat sears in the natural juices and nutrients f ound in quality cuts of meats.
Lighting the Rotisserie Burner 1. Push and turn on the control knob for the RO TISSERIE BURNER counterclockwise to the “HIGH” position (Fig. 31 and 32). W ait 5 seconds. 2. Press and hold the electronic igniter button (Fig. 32). Y ou w ill hear a snapping sound.
21 Good Bad Y ellow Blue Holes in Bur ner Y ellow Blue Burner Control Setting Tips • The high flame setting is too hot f or direct cooking. The high flame setting is good f or quick searing of meat, then finish cooking on medium or low flame settings .
22 Direct Method: • The heat source is directly below the f ood. • Use f or browning meat or cooking hot dogs and hamburgers, but check f ood frequently . • Use f or skillet and stir-fr y cooking, but limit the amount of oil and heat to be used.
23 REPRESENT A TIVE ILLUSTRA TION Steps For Cleaning V enturi: 1. Remove the cooking gr ates and the heat tents and set aside. 2. Using a 1/4” he x nut driver , remove the self-tapping scre ws holding the front heat shield (Fig. 38 and 39). Set the front heat shield aside.
CAUTION All cleaning and maintenance should be done only when the grill is cool & with the fuel supply tur ned off at the cylinder . If your g r ill is set up f or use with Natural Gas, turn off the gas supply at the system manual shut off v alve.
Please do not send other correspondence to the address belo w. PRODUCT REGISTRA TION DEP AR TMENT PO BO X 2931 WICHIT A ,KS 67201 A TTN: DEPT 586 IMPOR T ANT! Coleman ¨ Grill W arranty Registration Car d COMPLETE THE A TT A CHED REGISTRA TION CARD AND RETURN WITHIN 10 D A YS T O RECEIVE THESE IMPOR T ANT BENEFITS: CONFIRM Y OUR W ARRANTY : Y our prompt product registration confirms your right to the protection availab le under the ter ms and conditions of your Coleman ¨ w arranty .
7) Side burner (if applies) 8) Steamer/Fryer/W armer (if applies) 9) Side table design 10) Color of the grill (not including stainless steel) 11) Warming racks 12) Dependable igniter 13) Size of the grill (av ailable cooking square inches) 14) Integrated storage cabinet 15) Price 16) Rotisserie (if applies) 17) Other CONGRA TULA TIONS ON Y OUR NEW COLEMAN ® GRILL PURCHASE! If you ha ve any questions about y our product, please call Coleman Customer Ser vice at 1-800-356-3612.
27 TYPE 1 CONNECTION ILLUSTRA TION Ther mal Sensitive Handwheel 1-5/16" Acme Connection Nipple with Excess Flow V alve Regulator Y OUR NEW GAS GRILL IS EQ UIPPED WITH A TYPE 1 CONNECTION DEVICE WHICH HAS 3 SAFETY FEA TURES (FIG. 44): 1.
The Coleman Company , Inc. • 3600 N. Hydraulic • Wichita, KS 67219 U .S.A. 1-800-356-3612 • TDD: 316-832-8707 9992-034 (2/23/06) © 2006 The Coleman Company , Inc. All r ights reserved. Coleman ® and are registered trademarks of The Coleman Compan y , Inc.
An important point after buying a device Coleman 8450 Series (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Coleman 8450 Series yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Coleman 8450 Series - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Coleman 8450 Series you will learn all the available features of the product, as well as information on its operation. The information that you get Coleman 8450 Series will certainly help you make a decision on the purchase.
If you already are a holder of Coleman 8450 Series, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Coleman 8450 Series.
However, one of the most important roles played by the user manual is to help in solving problems with Coleman 8450 Series. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Coleman 8450 Series along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center