Instruction/ maintenance manual of the product ADC M55YU Aiwa
Go to page of 33
m!r DIGITAL AUDIO ADC”M55YU COMPACT DISC CHANGER CAMBIADOR DE DISCOS COMPACTOS OWNER’S RECORD For your convenience, record the model number and serial number (you will find them on the rear of your set) in the space provided below. Please refer to them when you contact your AIWA dealer in case of difficulty.
Welcome Thank you for your purchasing thw AIWA product. through this manual carefully. To optimize the performance of this unit, please read ● TABLE OF CONTENTS ■ FEATU13ES ● Tracks from 6 CDs stored in the disc magazine can be selected and played.
❑ PRECAUTIONS ● Do NOT install the unit in a location where it may be subjected to: — Direct sunlight or other sources of excessive heat — Fluid, rain or moisture — Excessive dirt or dust — Excesswe vibration ● This unit is designed to be operated on a 12-volt DC negative-ground electrical system only.
● UNPACKING Compact disc changer Compact disc magazine Connecting cable e Q , /’%0 o Supplied mounting kit for the compact disc changer The letters are keyed to those in the instructions. Use only the supplied mounting hardware for safe and secure installation.
● INSTALLATIONS Precautions Select the mounting location very carefully, referring to the following points. ● Make sure that there is no fuel tank, wiring or piping ontheothersideof the mounting surface. ● Make sure that the installation of the unit will not hinder the movement of the deck lid or interfere with the spare tire, etc.
● INSTALLATIONS Horizontal installation 1 Construction For details on @@@..., see page 3. N If St to the bottom surface of the car trunk, etc. with the tapping screws (not supplied).
Vertical installation 1 Construction For details on @@@..., see page 3. #- secure the plate brackets @ to the bottom surface of the car trunk, etc. with the tapping screws (not supplied). ● If installation space is narrow, bend the plate bracket@ back and forlh along the perforated line to break off the end.
● INSTALLATIONS Suspended installation Caution When installing the unit in the trunk below the Before drilling the holes, make sure that there is package tray, observe the following.
● CONNECTIONS This unit is cksigned Only for AIWA brand car stereo. Therefore you can not use the unit with other brand’s equipment. to AIWA brand car stereo +- Connecting cable (supplied) “~= Compact disc changer Caution Note Be sure to disconnect the ground wire terminal of ● Use only the supplied connecting cable.
● HOW TO USE How to use a compact disc magazirw 1 2 3 4 With the label side down, insert a CD all the way. Bottom of the magazine Recorded side Labeled side To remove a CD, pull part@ in the direction of the arrow as illustrated. Q o~ , 4°00 0 Slide the door to open.
~ SPECIFICATIONS Notes on the disc magazine ● Be sure to align the edge of the disc to both grooves of the disc tray when you set the disc. If a disc is not set properly, it may cause damage to the unit, Disc magazine Disc tray ● Thedisctraymay betakenoff from the magazine if you pull the tray forcibly.
Bienvenidos Muchas gracias por su compra de este producto AlWA. Para utilizar este aparato en Ias mejores condlciones posibles, lea cuidadosamente Ias mstrucciones de este manual. ● INDICE BDETALLES ● Se pueden seleccionar y reproducer canciones de 6 discos compactos colocados en el cargador de discos.
❑ PRECAUCIONES ● NOinstale launidaden un Iugardondepueda quedar expuesto a: — Ios rayos del sol o a temperatures muy altas. — Iiquido, Iluvia o humedad. — demasiada suciedad o POIVO — vibration excesiva ● Este aparato funciona solo con CC de 12 voltios con conexion a tlerra negativa.
● DESEMBALAJE Cambiador de discos Cargador de discos Cable de conexi6n compactos compactos Juego de montaje suministrado para el cambiador de discos compactos Las Ietras en circulos tienen sus referencias a 10 Iargo de Ias instrucciones. Utilice s610 Ias piezas para montaje suministradas para que la instalacion sea segura.
■ INSTALACIONES Precauciones Seleccione cuidadosamente el Iugar donde se va a instalar, teniendo en cuenta Ios siguientes puntos. ● Confirmeque no haya untanque decombustible detras de Iasuperficie de montaje yque tampoco haya cables o caiios.
~ INSTALACIONES Instalacion horizontal Nota Si fuera necesario reforzar la superficie de instaiacion, asegure Ias mensulas de placa @en la auperficie inferiordel batil del coche con tornillos autoterrajantes (no incluido). 2 3 Decida la position Desmontaje provisorio 5 ESPAiOL 4 5 Position del ojete protector.
Instalacilln vertical 1 Disefio Para mas detalles de @@@..., lea la pagina 3. con tornillos autoterrajantes (no incluido), ● El espacio para su instalacion es angosto, doble la mensula @ hacia atras Y hacia adelante a 10 Iargo de la Iinea peforada para romper la punts, 2 Decida la position F==%27- ,, .
● INSTALACIONES Instalacion colgada Precaution Cuando se instala la unidad en el baui, debajo de Verifique que no haya nada detras del Iugarde la la bandeja para paquetes, tenga en cuenta Ios instalaci6n antes de abrir Ios orificios. siguientes puntos.
● CONEXIONES Este aparato fue diseiiado solo para Ios estereos de coche AlWA. Por 10 tanto, no utilice este aparato con equipos de otra marca. al estereo de coche de la marca AIWA em Cable de conexi.
UTILIZATION Utilization del cargador de discos compactos A I COIOq.eelti,cocompacto hastaelfondo con el Iado con la etiqueta hacia abajo. Parte inferior del magaz[n Lado grabado Para sacar un disco compacto, tire de [a Parte @ en el sentido de la flecha, tal como se puede apreciar en la figura.
, UTILIZATION Utilizaci6n del cargador de discos compactos 1 2 3 4 Coloque el disco compacto hasta el fondo con el Iado con la etiqueta hacia abajo. IQ%. Parte inferior del magazin Lado grabado Lado con la Para sacar un disco compacto, tire de la parte @ en el sentido de la flecha, tai como se puede apreciar en la figure.
~ ESPECIFICACIONES Notas sobre e! cargador de discos ● Asegurese de alinear el horde del disco en ambas ranuras de la bandeja del disco cuando instale el disco.
Bienvenue Nous vous remercions d’avoir choisi ce produit AlWA. Pour optimiser ses performances, veuillez Iire attentivement ce mode d’emploi. ~ TABLE DES MATIERES ~ CARACTERISTIQUES ● Les pistes des 6 CD stockes clans Ie magasin a disques peuvent &re selectionnees et Iues.
❑ PRECAUTIONS ● NE PAS installer I’appareil a un endroit ou il pourrait 6tre soumis: — aux rayons directs du soleil ou a d’autres formes de temperature elevee. — a des Iiquides, a la pluie ou a I’humidite. — a une salete ou poussiere excessive.
● DEBALLAGE Changeurdedisque Magasin a disques Cable de raccordement compact Kit de montage fourni pour Ie changeur de disque compact Les Iettres correspondent a celles du mode d’emploi. Utiliser uniquement Ies fixations de montage fournies pour assurer une installation stire.
~ INSTALLATION Precautions Choisir I’emplacement de montage tres soigneusement en verifiant Ies points suivants: ● Verifier qu’il n’y a pas de reservoir a carburant, c~blage ou tuyauterie derriere la surface de montage.
~ INSTALLATION Installation horizontale 1 Construction Pour Ies details sur @@@... voir la page 3. ( -1 I Remarque ‘L! Si la surface de montage doit etre renforcee, fixer Ies plaques de soutien @ sur Ie dessous b du coffre de la voiture, etc. avec des vis taraudeuses (non fourni).
Installation verticale 1 Construction Pour Ies details sur @@@... voir la page 3. . .. .. . ..w 2 Selection de la position 3 R@rait ternporaire ae la Decoupage de trous clans la moque~e / v.
~ INSTALLATION Installation suspendue Precaution A I’installation de I’appareil clans Ie coffre sous la Verifier qu’il n’ya rien de I’autre c6te de Iasurface planche a paquets, respecterles points suivants. de montage avant de perter Ies trous.
gRACCORDEMENTS Cet appareil est con~u seulement pour une stereo automobile AlWA. II ne peut pas &Mre utilise avec des equipments dautres marques. a une stereo auto de marque AIWA +m Cable de racco.
❑ UTILISATION Comment utiliser Ie magasin a disques 2 3 Inserer Ie CD a fond, son c6te etiquete dirige vers Ie has. Dessous du magasin C6te enregistre C6te etiquette Pour retirer un CD, tirer la partie @ clans Ie sens de la fleche comme indique. Faire glisser la porte pour I’ouvrir.
● SPECIFICATIONS Remarques sur Ie magasin a disques ● Bien aligner Ie bord du disque sur les deux cannelures du plateau a disque en I’installant. Un disque mal place peut endommager I’appareil. Magasin a disques Plateau a disque ● Le plateau a disque peut se detacher du magasin s’il est tire avec force.
88-KM3-901 -01 9801 30 BTM-OX Printed in Japan AIWA CO.,LTD..
An important point after buying a device Aiwa ADC M55YU (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Aiwa ADC M55YU yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Aiwa ADC M55YU - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Aiwa ADC M55YU you will learn all the available features of the product, as well as information on its operation. The information that you get Aiwa ADC M55YU will certainly help you make a decision on the purchase.
If you already are a holder of Aiwa ADC M55YU, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Aiwa ADC M55YU.
However, one of the most important roles played by the user manual is to help in solving problems with Aiwa ADC M55YU. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Aiwa ADC M55YU along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
