Instruction/ maintenance manual of the product GL36STE FMI
Go to page of 20
For more information, visit www .fmiproducts.com NA TURAL GAS MODELS (V)GL36ST AND (V)GL36STE PROP ANE/LP GAS MODELS (V)GL36STP AND (V)GL36STEP 2-SIDED (SEE-THROUGH), VENTED DECORA TIVE GAS APPLIANCE .
www .fmiproducts.com 55173H 2 W ARNING: Improper installation, adjustment, altera - tion,service ormaintenancecan causeinjury orprop - erty damage. Refer to this manual for correct installation and operational procedures.
www .fmiproducts.com 55173H 3 SAFETy INFORMA TION W ARNING: This product c o n t a i n s a n d / o r g e n e r a t e s chemicals known to the State of California to cause cancer or birth defects or other reproduc - tiveharm.
www .fmiproducts.com 55173H 4 11. Keep the area around your replace clear of combustible materials, gasoline and other ammable vapor and liquids. Do not run re- place where these are used or stored. Do not place items such as clothing or decorations on or around replace.
www .fmiproducts.com 55173H 5 Figure 2 - T ypical T wo-Sided Fireplace Installation INTRODUCTION Models (V)GL36ST/P and (V)GL36STE/EP are decorative gas appliances that use a millivolt gas control and piezo pilot or an electronic gas control valve with an electronic ignition system respectively .
www .fmiproducts.com 55173H 6 Figure 3 - Clearances from T op V iew Figure 4 - Clearances from Side V iew MANTEL CLEARANCES W oodwork, such as wood trims, mantel s and other comb ustib le materia ls, should not be placed within 7" of the opening of this appliance (see Figure 5).
www .fmiproducts.com 55173H 7 FIREPLACE INST ALLA TION Continued FRAMING Construct framing using dimensions shown if Figures 6, 7 and 8. (Use the gure applicable to your application.) Figure 6 shows the framing dimensions prior to having the appliance in place.
www .fmiproducts.com 55173H 8 FIREPLACE INST ALLA TION Continued OPTIONAL OUTSIDE AIR KIT (MODEL AK-4) The installation of an outside air kit should be completed during the rough framing of the re- place due to the nature of it's location. Outside combustion air is accessed through a vented crawl space.
www .fmiproducts.com 55173H 9 FIREPLACE INST ALLA TION Continued GAS SUPPL Y TESTING Note: This section is intended as a guide for quali - ed technicians installing gas to this appliance. CAUTION: Do not connect appliancebefore pressuretest - ing gas piping.
www .fmiproducts.com 55173H 10 T o install: 1. Remove gas line cover plate from appliance’ s outer surround at the location to be used. 2. Remove insulation from inside the gas line conduit sleeve. 3. Run gas line through sleeve. 4. Prepare incoming black iron gas line with T eon tape or pipe joint compound.
www .fmiproducts.com 55173H 11 FIREPLACE INST ALLA TION Continued MANTELS Mantels, combustible or non-combustible, may be constructed as long as proper clearances are observed (see Figure 2, page 6 and Clearances , page 6). PILOT ASSEMBL Y ADjUSTMENT The pilot assembly is factory preset for the proper ame height.
www .fmiproducts.com 55173H 12 OPTIONAL GLASS DOOR Glass doors are optional with this gas appliance (see Replacement Parts and Accessories , page 19). Installing Glass Door 1. Be sure top spring clip hole is aligned with hole in replace frame (see Figure 21).
www .fmiproducts.com 55173H 13 OPERA TING FIREPLACE MILLIV OL T MODELS FOR YOUR SAFETY READ BEFORE LIGHTING W ARNING: If you do not fol- low these instructions exactly , a re or explosion may result causing property damage, per - sonalinjuryorlossoflife.
www .fmiproducts.com 55173H 14 TO TURN OFF GAS TO APPLIANCE 1. T urn off the wall switch. 2. T urn off all electric power to the appliance if service is to be performed. 3. Remove control access panel. 4. Pus h in gas con tr ol knob and tur n clock wis e to “OFF”.
www .fmiproducts.com 55173H 15 CLEANING AND MAINTENANCE W ARNING: Installation and repair should be done by a qualied service person. The applianceshouldbeinspected before each use and at least annuallyby a qualiedservice person.
www .fmiproducts.com 55173H 16 DO NOT CONNECT N.C.SW HE A T LIMIT SWITCH TH/TP TP TH WA LL SWITCH (SUPPLIED) TO 120V THERMOPILE PILOT IGNI TO R O F F P I L O T O N PILO T SAFET Y WIRE MAIN GAS INCOMING SUPPL Y MILLIVOL T WIRING DIAGRAM STEP DOWN TRANSFORMER EV2 SUPPL Y INCOMING MAIN GAS EV1 TO GAS LINE BURNER 24V AC N.
www .fmiproducts.com 55173H 17 TROUBLESHOO TING MILLIVOL T SYSTEM Note: Before troubleshooting the system, make sure the gas shutoff valve is ON. The two most common causes of a malfunctioning gas appliance are: 1.
www .fmiproducts.com 55173H 18 TROUBLESHOO TING ELECTRONIC IGNITION SYSTEM Note: Before troubleshooting the system, make sure the gas shutoff valve is ON. The two most common causes of a malfunctioning gas appliance are: 1. Loose wiring connections 2.
www .fmiproducts.com 55173H 19 REPLACEMENT P ARTS AND ACCESSORIES Purchase these replace replacement parts and accessories from your local dealer . If they can not supply these parts, call FMI PRODUCTS, LLC at 1-866-328-4537 for referral information.
55173 Rev . H 09/09 WARRANTy KEEP THIS WARRANTy FMI PRODUCTS, LL C LIMITED WARRANTIES NewProducts Standard Warranty: FMI PRODUCTS, LLC warrants this new product and any parts thereof to be free fro.
An important point after buying a device FMI GL36STE (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought FMI GL36STE yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data FMI GL36STE - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, FMI GL36STE you will learn all the available features of the product, as well as information on its operation. The information that you get FMI GL36STE will certainly help you make a decision on the purchase.
If you already are a holder of FMI GL36STE, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime FMI GL36STE.
However, one of the most important roles played by the user manual is to help in solving problems with FMI GL36STE. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device FMI GL36STE along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
