Instruction/ maintenance manual of the product MWT4461WW Amana
Go to page of 12
Read all instructions before starting installation. Important--Save these instructions for electrical inspector's use. Over the Range Microwave Oven Installation Instructions MWT4461D MWT4461WW M.
2 Important Safety Instructions Recognize this symbol as a SAFETY message Installation Requirements Caution To avoid personal injury, mounting surface must be capable of supporting microwave oven (65 lbs.) and oven loads (up to 50 lbs.) for a total weight of 115 lbs.
3 Materials Needed (Not Supplied) • Phillips screwdriver • Pencil • Ruler or tape measure and straight edge • Protective gloves • Carpenter square (optional) • Tin snips (in some applicati.
4 Installation Instructions Outside Back Exhaust (Horizontal Duct) 1. Slide exhaust adaptor to one side, squeeze sides and remove. Save damper and exhaust adaptor. See diagram above. 2. Remove and save 5 screws holding blower plate to microwave oven. 3.
5 7. Guide wires into duct while placing blower unit back into opening. 9. Fit exhaust adaptor into house duct. Be sure damper hinge is on top and damper swings free into wall outlet. 10. Remove paper from sticky side of 28 inch foam tape strip. Press sticky side onto front edge of exhaust adaptor.
6 5. Carefully pull out blower unit. Wires extend far enough to allow blower adjustments. 6. Roll blower unit so blades face towards front of microwave oven. Wires should be routed in front of motor frame. 7. Guide wires into duct while placing blower unit back into opening.
7 1. Find studs, using one of following methods: • Stud finder--magnetic device which locates nails. • Use hammer to tap lightly across mounting surface to find solid sound. This will indicate stud location. Note: After locating stud or studs, stud center can be found by probing wall with small nail to find edges of stud.
8 4. Insert 2 screws with washers through top cabinet holes and tighten to top of microwave oven. (While tightening screws, lift front side of microwave oven and push toward wall.) 5. Install rectangular washer under microwave oven for extra stability.
9.
10.
11.
1994 Amana Refrigeration, Inc. Amana, Iowa 52204 Part No. C8935506 Printed in U.S.A. .
An important point after buying a device Amana MWT4461WW (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Amana MWT4461WW yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Amana MWT4461WW - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Amana MWT4461WW you will learn all the available features of the product, as well as information on its operation. The information that you get Amana MWT4461WW will certainly help you make a decision on the purchase.
If you already are a holder of Amana MWT4461WW, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Amana MWT4461WW.
However, one of the most important roles played by the user manual is to help in solving problems with Amana MWT4461WW. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Amana MWT4461WW along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
