Instruction/ maintenance manual of the product AS162ATNBA Haier
Go to page of 19
AS072AZNBA A U072ABNCA (HSU-07CG03/R1) AS092AMNBA A U092ABNCA (HSU-09CG03/R1) AS122A YNBA A U122ABNCA (HSU-12CG03/R1) AS162A TNBA A U162AFNBA (HSU-16CG03/R1) AS182ASNBA A U182AFND A (HSU-18CG03/R1) AS222AJNBA A U222AHNBA (HSU-22CG03/R1) No .0010544375 Please read this operation manual bef ore using the air conditioner .
Contents Cautions P ar ts and functions Operation Maintenance T roub le shooting 1-2 3-5 6-13 14-16 17.
Cautions 1 The cardboard bo x may be brok en or cut into.
2 Series 07,09,12 16,18 22 3G2.5mm 2 +3x0.75mm 2 4G1.5mm 2 T ype 3G1.5mm 2 +2x0.75mm 2 20.
P ar ts and Functions Operation mode indicator Lights up when Timer operation is selected. Lights up during compressor running. Lights up when unit starts. Air filter V er tical flap Timer mode indicator Inlet grille Air filter Inlet grille Use remote controller to adjust up and down air flow .
.
P ar ts and Functions 5 Operation 1. Mode display A UTO COOL DRY F AN 2. SWING display 3. F AN SPEED displa y 4. HEAL TH display 5. SLEEP display 6. LOCK display 7. TIMER ON display 8. A UXILIARY HEA T display 9. SWING 10. MODE Used to select A UTO,COOL,DR Y ,HEA T and F AN 1 1.
Operation 6 Remote controller's operation When in use, put the signal tr ansmission head directly to the receiv er hole on the indoor unit. The distance between the signal transmission head and the receiv er hole should be within 7m without any obstacle as well.
LOCK RESET CODE MODE SLEEP CLOCK SET TIMER A F AN TEMP ON OFF 1 2 4 3 7 SWING 9.
Operation 8 COOL and DR Y operation A UT O DR Y F AN COOL A UTO A UT O LO MED HI (1) Unit star t (2) Select operation mode (3) Select temp . setting Press MODE button. F or each press, oper ation mode changes as f ollows: Unit will run in operation mode displa yed on LCD .
Operation 9 It is advisable not to k eep v er tical flap at downw ard position for a long time in COOL or DR Y mode, otherwise, condensate water might occur . When humidity is high, condensate water might occur at air outlet if all horizontal louv ers are adjusted to left or r ight.
Operation 10 Hints Set Clock correctly bef ore star ting Timer operation(ref err ing to page 5) Y ou can let unit star t or stop automatically at f ollowing times: Before y ou wak e up in the mor ning, or get bac k from outside or after you f all asleep at night.
Operation 11 TIMER ON-OFF T o cancel TIMER mode (1)After unit star t, select your desired oper ation mode Operation mode will be displa yed on LCD . P ower indicator on indoor unit lights up . (2) Press TIMER button to change TIMER mode. Ev er y time the button is pressed, displa y changes as follo ws: Select TIMER ON-OFF .
Oper ation 12 In COOL ,DR Y mode Approx. 6 hrs T emp. setting Unit stop One hour after SLEEP mode star ts, temp . will become 1 o C higher than temp . setting. After running for another 1 hour , temp . r ises b y 1 o C fur ther . Unit will run for 6 hours then stops automatically .
Oper ation 13 Emergency Operation: Carr y out this operation only when the remote controller is def ective or lost. When the emergency operation s witch is pressed, a " Pi " sound star ts once, which means the star t of this operation.
14 2.Remov e air filters Push up the filter's center tab slightly until it is caesura of the stopper . Remov e it b y pulling down. 4.Attach the filters Attach filter behind the stopper so that the " F ront " indication is facing to the front.
15 Maintenance Open the frame of the filter . Attach the Electrostatic Filters. If Electrostatic Filter can no longer be used, please buy a ne w one instead. 2 1 3 4 5 6 Some of the models ma y not hav e the frame of the filter . Replacement of Electrostatic Filter Detach the Air filters.
16 Maintenance Proper room temperature . Closing of doors and windows during operation. Eff ectiv e use of the timer . Ne v er f ail to obser ve the f ollowings Do not b lock the inlet or outlet. Do not use f or other pur poses . Do not pull pow er plug.
17 Bef ore asking f or ser vice, chec k the follo wing first. Cause or check points When unit is stopped, it won't restar t immediately until 3 minutes ha ve elapsed to protect the system. When the electric plug is pulled out and reinser ted, the protection circuit will work f or 3 minutes to protect the air conditioner .
An important point after buying a device Haier AS162ATNBA (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Haier AS162ATNBA yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Haier AS162ATNBA - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Haier AS162ATNBA you will learn all the available features of the product, as well as information on its operation. The information that you get Haier AS162ATNBA will certainly help you make a decision on the purchase.
If you already are a holder of Haier AS162ATNBA, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Haier AS162ATNBA.
However, one of the most important roles played by the user manual is to help in solving problems with Haier AS162ATNBA. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Haier AS162ATNBA along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
