Instruction/ maintenance manual of the product CGDE700AW Haier
Go to page of 25
Electric Dryer Sèche -linge Genesis Secadora Eléctrica User Manual Model # HLF103Q/R, GDE700AW , CHLF103Q , CGDE700AW Guide de l’Utilisateur Modéle # HLF103Q/R, GDE700AW , CHLF103Q , CGDE700AW Ma.
IMPORT ANT SAFETY INSTRUCTIONS WARNING - T o reduce the risk of fire, electric shock, or injury to persons when using your appliance, follow the basic precautions, including the following: 1. Read all of the instructions before using this appliance. 2.
2 Thank you for using our Haier product. This easy-to-use manual will guide you in getting the best use of your dryer . Remember to record the model and serial number . They are on a label in back of the dryer . Model number Serial number Date of purchase Staple your receipt to your manual.
English 3 T able Of Contents PA G E SAFETY INSTRUCTIONS .................................................................... 1 INST ALLA TION INSTRUCTIONS ................................................ 4-12 T ools and Materials Required ............
English 4 • Select a suitable location for the dryer on a hard even surface away from direct sunlight or heat sources, baseboard heaters, cooking appliances etc. Any floor unevenness should be corrected with leveling legs located on the bottom of the dryer .
English 5 Exhaust System Connections 1. Do not use plastic flexible duct to exhaust the dryer . Excessive lint can build up inside exhaust system and create a fire hazard and restrict air flow .
English 6 Materials Use only 4 inch (10.2cm) diameter (minimum) rigid of flexible metal duct and approved vent hood which has a swing-out damper hat open when the dryer is in operation. When the dryer stops, the dampers automatically close to prevent drafts and the entrance of insects and rodents.
English 7 Location of Y our Dryer Do Not Install Y our Dryer: • In an area exposed to dripping water or outside weather conditions. • In an area where it will come in contact with curtains, thick carpet,or any thing that will obstruct the flow of combustion and ventilation air .
English 8.
English 9 Electrical Connections Requirements and Instructions The following are specific requirements for proper and safe electrical installation of your dryer . Failure to follow these instructions can create electrical shock and/or fire hazard. W ARNING 1.
English 10 3- W ire Cord Connections (USA only) 1. Remove the screws securing the terminal block access cover and the strain relief mounting bracket located on the back of the dryer upper corner . 2. Install a U .L . approved strain relief into the power cord entry hole of the mounting bracket.
English 11 4- W ire Cord Connections 1. Remove the screws securing the terminal block access cover and the strain relief mounting bracket located on the back of the dryer upper corner . 2. Install a UL approved strain relief into the power cord entry hole of the mounting bracket .
English 12 4. Thread a U .L. approved 30 Amp power cord. NEMA 14-30 type ST or SRDT through the strain relief . 5. Attach the green power cord ground wire to the cabinet with green ground screw .
English 13 OPERA TING INSTRUCTIONS Understanding the Control Panel Note: Features may vary per model. Start/Pause Button: (1) • P ress the button to turn the dryer ON . P ress this button once to start the dry process. Press this button once again to pause the activity during the dry cycle.
English 14 More Time & Less Time Button: (7) • Set time from 0 to 180 minutes when Timed Dry or Rack Dry cycle selected. Timed-Dry Cycles Button: (8) • "Timed-Dry Cycles" button will let you select your desired dry mode.
English 15 PREP ARA TIONS BEFORE DRYING • Sort the clothes of the same kind (cotton, synthetics, woolen) to dry . • Dark and light colored clothes should be separately dried. F abrics prone to losing lint and those prone to adhering lint shall be separately dried.
English 16 • The appropriate load shall be 1/3 ~ 1/2 of the drum volume. Avoid too much load, space is needed to allow clothes free rotation for uniform and wrinkle proof drying. • When drying big articles, only 2-3 pieces shall be loaded at a time and supplemented with small and medium sized articles.
English 17 2. Press "Auto-Dry Cycles" button to select a suitable full automatic cycle. • The Normal program will be automatically selected after powering on. If another full automatic program is desired, press "Auto-Dry Cycles" button until corresponding indicator turns on.
18 F rançais 4. Press "T emp" button to set a suitable drying temperature. • After switching on, the dryer sets corresponding temperature adapting to different program selected. If other drying temperature is wanted, press "T emp" button to enable such a selection.
19 F rançais TIMED DRY CYCLE 1. Press any button except "Off" button to power on. 2. Press "Timed-Dry Cycles" button and select "Timed Dry" cycle. • After powering on, press "Timed-Dry Cycle" button to select "Timed Dry" program.
20 F rançais RACK DRY CYCLE 1. Press any button except "Off" button to power on. 2. Press "Timed-Dry Cycles" button and select "Rack Dry" cycle. • After powering on, press "Timed-Dry Cycle" button to select "Rack Dry" program.
21 The following sounds are normal during the operation of the dryer . • T umbling sound: this is normal as the heavy wet clothes in the dryer are continuously being tossed around. • Air rushing noise: this happens as the dryer drum spins at very high RPM and the air is rushing through the dryer drum.
22 TROUBLE SHOO TING Dryer does not operate: • Check if unit is plugged in. The plug may have come loose. • Check if the electrical wall receptacle is of proper voltage. • Check if the circuit breaker needs to be reset or if the fuse needs to be replaced.
LIMITED W ARRANTY Full ONE Y ear W arranty F or 12 months from the date of original retail purchase, Haier will repair or replace any part free of charge including labor that fails due to a defect in materials or workmanship.
Made in China Fabriqué en Chine Hecho en China Haier America New Y ork, NY 10018 Printed in China HLF103Q Issued: JUL Y 2006 IMPORT ANT Do Not Return This Product T o The Store I f you have a problem with this product, please contact the "Haier Customer Satisfaction Center" at 1-877-337-3639.
An important point after buying a device Haier CGDE700AW (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Haier CGDE700AW yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Haier CGDE700AW - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Haier CGDE700AW you will learn all the available features of the product, as well as information on its operation. The information that you get Haier CGDE700AW will certainly help you make a decision on the purchase.
If you already are a holder of Haier CGDE700AW, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Haier CGDE700AW.
However, one of the most important roles played by the user manual is to help in solving problems with Haier CGDE700AW. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Haier CGDE700AW along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
