Instruction/ maintenance manual of the product KFR 28GWE Hisense Group
Go to page of 23
- KFR 33GWE - KFR 33GWE Hisense Corporation INSTR UCTION INSTR UCTION MANU AL MANU AL - KFR 28GWE - KFR 28GWE - KFR 25GWE - KFR 25GWE SPLIT TYPE AIR CONDITIONER SPLIT TYPE AIR CONDITIONER - KFR 2101GW.
RZA-0-1000-862-SM-D Compact Size This model is smaller than its predecessors and yet offers the same capabilities. Microprocessor Controlled Operation The interior compartment of the remote control unit contains several features to facilitate automatic operation, clearly displayed for easy use.
Contents 1 Page Alert symbol Caution statements Composition of the air conditioner Operation guide Care and cleaning Tips for energy saving Troubleshooting Schematic diagram Pardon not to inform you if the contents of the manual changes.
Caution Statements W ARNING W ARNING W ARNING CAUTION 2 1.Do not turn the air conditioner on and off from the power mains switch. Use the ON/OFF operation button. 2.Do not stick anything into the air outlet of the outdoor unit. This is dangerous because the fan is rotating at high speed.
Air intake grille INDOOR UNIT Air outlet Remote control unit Drain hose Refrigerant tubes OUTDOOR UNIT Air outlet Composition of the Air Conditioner 3 1.Diagram of Structure This air conditioner consists of an indoor unit and an outdoor unit.
INDOOR UNIT OPERATING lamp TIMER lamp POWER lamp POWER TIMER OPERATING HIGH POWER lamp REMOTE CONTROL receiver ON/OFF button 4 2.Introduction of the Indoor ControI Unit IMPORTANT : Avoid using radio equipment such as mobile phone near (within 1m) the indoor unit.
Displayed when one-hour OFF timer is enable Displayed when setting timer Displayed when setting temperature Displayed when transmitting data Displayed when temperature is shown Displayed when temperat.
关 预约 1HR HIGH POWER ON/OFF TEMP ＯＮ ＯＦＦ AUTO 1 小时 x C 1HOUR 1HOUR FLAP ON OFF SET CANCEL A/C SENSOR BAT TERY F AN SPEED MODE SENSOR A/C SENSOR button Transmitter Battery compartment (pull off the cover to expose the batteries.) (Cover closed) SET TEMP HOUR HOUR AUTO AUTO ACL SLEEP TEMP .
:The air conditioner starts at the set time. The air conditioner stops at the set time. or :The air conditioner makes the room warm. :The air conditioner reduces the humidity in the room. direction to one of the six possible positions manually, or to select the The airflow direction can be set manually.
Operation Guide Ｂ ACL button 1. Slide the cover in the direction indicated by the arrow and remove it. 2. Install two AAA alkaline batteries. Make sure the batteries point in the direction m arked in the battery compartment. 3. Use a thin object such as the tip of a pen to press the ACL button.
Operation with the Remote Control Unit(continued) C 1HR ON/OFF TEMP HIGH POWER FLAP ON OFF SET CANCEL SLEEP A/C SENSOR ACL BATTER Y FA N SPEED MODE STEP 3 STEP 2 STEP 5 AUTO AUTO STEP 4 STEP 1 NOTE Check that the circuit breaker on the power panel is turned on and that the operation selector of the indoor unit is in the ON position.
Adjusting the Fan Speed AUTO AUTO A. Automatic Simply set the FAN SPEED selector to the position. A microcomputer in the air conditioner automatically controls the fan speed when the mode is selected.
Adjusting the Airflow Direction The horizontal airflow can be adjusted by moving the vertical vanes with your hands to the left or right. 2. Vertical 1. Horizontal ! CAUTION When the humidity is high, the vertical vanes should be in the front position during the cooling or dehumidifying operation.
Night Setback / Simultaneous Use Energy Saving C 1HR ON/OFF TEMP HIGH POWER FLAP ON OFF SET CANCEL SLEEP A/C SENSOR ACL BATTER Y FA N SPEED MODE AUTO AUTO ● Night Setback Mode Night Setback Mode is used for saving energy. Press the SLEEP button in operation.
ＯＮ HOUR HOUR Using the 12-Hour ON and OFF Timer C 1HR ON/OFF TEMP HIGH POWER FLAP ON OFF SET SLEEP A/C SENSOR ACL BATTER Y FA N SPEED MODE STEP 2 STEP 3 STEP 1 1.TIMER ON mode (Example) After the length of time set for TIMER ON elapses, the unit begins operating.
Using the 1-Hour OFF Timer 14 C 1HR ON/OFF TEMP HIGH POWER FLAP ON OFF SET SLEEP A/C SENSOR ACL BATTER Y FA N SPEED MODE AUTO AUTO 1HOUR 1HOUR This function causes the unit to operate for one hour and then stop, regardless of whether the unit is on or off when this button is pressed.
15 Special Remarks Heating ( ) Operation Heating performance Defrosting POWER lamp ● Because this air conditioner heats a room by drawing on the heat of the outside air (heat pump system), the heating efficiency will fall off when the outdoor temperature is very low.
Operation without the Remote Control Unit INDOOR UNIT Care and Cleaning NOTE If you have lost the remote control unit or it has trouble, follow the steps below. 1.When the air conditioner is not running If you want to turn on the air conditioner, pressing the ON/OFF button once.
Care and Cleaning (continued) Anti-Mold Filter How to remove the anti-mold filter The anti-mode filter behind the air intake grille should be checked and cleaned at least once every three weeks. 1.Grasp both ends of the air intake grille and pull it out and up.
Tips for Energy Saving Do not ● Block the air intake and outlet of the unit. If they are obstructed, the unit will not work well, and may be damaged. Let sunlight directly into the room. Use sunshades, blinds or curtains. If the walls and ceiling of the room are warmed by the sun, it will take longer time to cool the room.
Schematic Diagram 2. Refrigerant Flow Diagram KFR-33GWE AC,230V/50Hz 1220W/1260W 3300W/3550W 。 8m/80 15m 3 450m /h R22/1.30kg 1. Main specifications of the product Type Power source Power .
1 2 3 4 5 S R C TO INDOOR TERMINAL COMP FAN MOTOR RV YLW/GRN BLK RED RED BLK WHT BLU BLU WHT GRY CAP A YLW/GRN YLW/GRN BRN CAPA PNK 4 WAY V ALUE ASSY 4.
P ACKING LIST NO. NAME AMOUNT PACKING LOCA TION 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. OUTDOOR UNIT POWER CABLE DRAINAGE ELBOW * AIR FRESH FIL TER INDOOR UNIT INSTRUCTION MANUAL INSTALLA TION MANU.
An important point after buying a device Hisense Group KFR 28GWE (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Hisense Group KFR 28GWE yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Hisense Group KFR 28GWE - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Hisense Group KFR 28GWE you will learn all the available features of the product, as well as information on its operation. The information that you get Hisense Group KFR 28GWE will certainly help you make a decision on the purchase.
If you already are a holder of Hisense Group KFR 28GWE, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Hisense Group KFR 28GWE.
However, one of the most important roles played by the user manual is to help in solving problems with Hisense Group KFR 28GWE. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Hisense Group KFR 28GWE along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
