Instruction/ maintenance manual of the product Compaq L5009tm HP
Go to page of 38
L5006tm and L5009tm Touchscreen Monitors User Guide .
© 2006–2009 Hewlett-Packard Development Company, L.P. Microsoft, Windows, and Windows Vista are either trademarks or register ed trademarks of Microsoft Corporation in the United States and/or other countries. Elo TouchSystems, IntelliTouch and TouchTools are trademarks of Tyco Electronics Corporation.
About This Guide This guide provides information on setting up the monito r, installing dri vers, using the on-screen displa y menu, troubleshooting and technical specifi cations. WARNING! Text set off in this manner in dicates that failure to follow di rections could result in bodily harm or loss of life.
iv About Thi s Guide ENWW .
Table of contents 1 Product Features HP L5006tm Touchscreen ....................... ............... ............... ............... .............. ............... ....... ............ 1 HP Compa q L5009t m Touch screen ....... ........ .......... .
OSD and Power Lock/U nlock ............ ............ ............ ............ .......... ............ ............ ............ ....... ....... . 15 Appendix A Troubl eshooting Solving Common Problems ................... ............ ............
1 Product Features The LCD (liquid crystal display) monitors have an ac tive matrix, thin-film tran sistor (TFT) pan el. The monitors featur e: HP L5006tm Touchscreen ● Maximum resolution of XG A 1024 x 768.
HP Compaq L5009tm Touchscreen ● Maximum resolution of XGA 10 24 x 768. Compatible wi th VGA, SVGA and XGA (non-interlace) color video cards ● Integrated Acoustic Pulse Recognition (APR) te chn o.
2 Safety and Maintenance Guidelines Important Safety Information A power cord is included with the monitor. If anot her cord is used, use only a power source and connection appr opriate for this moni tor. For information on th e correct power cord set to use with th e monitor, r efer to the Power Cord Set Requirements o n page 29 in Appendix C.
Maintenance Guidelines To enhance th e performance an d extend the life of the monito r: ● Do not open th e monitor cabinet or attempt to se rvice this product yourself. Adjust onl y those controls that are covered in th e operating instruct ions.
3 Setting Up the Monitor To set up the monitor, en sure that the power is turned off to the mon itor, computer system, and other attached devices, then foll ow the instructions below. Identifying Rear Connectors Figure 3 -1 Rear Conn ectors Connector Function 1 AC Power Connects the AC power cord to the monitor.
Connecting the Cables NOTE: For the L5009tm model, it is bes t to install the APR driver b efore connecting the ha rdware. 1. Place the monito r in a convenie nt, well-v entilated locatio n near the computer. 2. Connect one end of the p ower cable (1) to the AC power connecto r on the back of the moni tor, and the other end to an electrical wall outlet.
Installing the Serial or USB Touch Drivers The Touch driver software can be downlo aded from th e Web or from the HP software and documentation CD included with the monitor. Downloading Drivers from the Web 1. Insert the HP software and documentati on CD in the co mputer’s CD-ROM d rive.
Removing the Monitor Stand If you are mou nting the panel to a wall or other mo unting fixture, you must remove the monitor stand from the panel. The mo nitor has four mounting holes on the back side of the panel that adheres to the VESA mounting standard.
Tilting the Monitor For viewing clarity, tilt th e moni tor forward (u p to -5 degrees) or backward (up to 90 degrees). Figure 3 -3 Tilting the Monitor CAUTION: In order to protect the monitor, be sure to hold the base when adjusting the LCD, and take care not to touch th e screen.
4 Operating the Monitor Installing the Monitor Driver The CD that comes with the monitor contai ns monito r driver files you can in stall on your computer: ● an .INF (Information) file ● an .ICM (Image Color Match ing) file PDF Complete is supplie d on this CD and can be i nstalled from the menu.
Installing the .INF and .ICM Files After you determi ne that you nee d to update, you can install the .INF and .ICM files from the CD or download the m. Installing from the CD To install the .INF and .ICM files on the computer from the CD: 1. Insert the CD i n the computer CD-ROM d rive.
Front Panel Controls Table 4- 1 Monitor Fr ont Panel Co ntrols Control Function 1 Power Turns the monitor on or off. 2 Select Selects the adjustment items from the OSD menus. 3 Enter the brightness adjustment. Decrease value of the a djustment item.
Using the On-Screen Display Use the On-Screen Display (OSD) to display and se lect OSD menu fu nctions. To access the OSD, do the following: 1. Press the Menu button on the side panel to activate th e OSD menu. 2. Use the up arrow or down ar row controls to move clockwise or countercloc kwise through th e menu.
Icon OSD Control Description OSD Language Selects the language in which the OSD menu is displayed. Information Description Indicates the curr ent resolution, H-Frequency and V-Fr equency. NOTE: When adjusting th e Clock and Clock Phase valu es, if the mon itor images become distorted, continue adjusting th e values until the distortio n di sappears.
OSD and Power Lock/Unlock The OSD feat ure can be locked a nd unlocked. The mo nitor is shipped with th e OSD menu and power button in th e unlocked p osition. To lock the OSD menu: 1. Press the Menu b utton and up arrow button s imult aneously until a window displa ys "OSD Unlock.
A Troubleshooting Solving Common Problems The following tab le lists possible problems, the poss ible cause of each problem, and the recommended solutions. Problem Possible Cause Solution Screen is blank. Power cord is disconnected. Connect the power cord.
Touchscreen Tips If you experience operational issues with the touchscreen system either during or after installation, use the tips below to help you deter mine the source of th e problem. ● If “No Elo touchmonitor found” i s displayed on the screen, install the latest drivers.
If the touchscreen is no t responding to tou ch, check y our serial or USB connection by doing the following: ● Serial Connection - Run the comd ump diagnostic utility to determin e if the touchscreen, the serial touch controller, the computer's serial COM port and the associated cablin g are connec ted and functioning properly.
6. Exit regedit when done. 7. Shut Down and r estart the machine. A re start is required before the setting will take effect. A cursor is not visible. To make the cursor visible, first, open Control Panel > Elo Touchscr een > Mode tab.
B Technical Specifications NOTE: All performance specificatio ns are provided by the co mponent manufa cturers. Performanc e specifications represent the highest specification of a ll HP's componen t manufacturers' typical level specifications for performance and actual pe rformance may vary either higher or lower.
OSD Contrast, Brightness, H-Position, V- Position, Color Temperature, Phase, Clock, OSD Time, Recall, Language Plug & Play DDC1/2B Touch Panel IntelliTouch Surface Acoustic Wave (SAW) technology Power Input AC 100-240V, 50-60Hz Operating Conditions Temperature (Operating) Temperature (Storage) Humidity Altitude 0° C to 40° C (32° F to 104° F) -20°C to 60°C (-4°F to 14 0°F) 20% ~ 80% (No Condensation) To 3657.
Display Color 16.2M Viewing Angle Vertical -60° ~ +40° Horizontal -60° ~ +60° Input Signal Video Sync R.G.B. Analog 0.7Vp-p, 75 Ohms TTL Positive or Negative Signal Connector Mini D-Sub 15 pin Side Control Menu, up arrow, down arrow, Select, Power OSD Contrast, Brightness, H-Position, V- Position, Color Temperature, Phase, Clock, OSD Time, Recall, Language Plug & Play DDC1/2 B Touch Panel Acoustic Pulse Recognition (APR) Technology Power Input AC 100-240V, 50-60Hz Operating Conditions Temperature (Operating) Tempe ratur e (Sto rage) Humidit y Altitude 0° C to 40° C (32° F to 104 ° F) -20°C to 60°C (-4°F to 140°F) 20% ~ 80% (No Condensation) To 3657.
IntelliTouch Surface Acoustic Wave Technology Table B -3 IntelliT ouch Spec ifications Input Method Finger or gloved hand (cloth, leather o r rubber) activation. Mechanical Positional Accuracy Standard deviation of error is less than 2.03 mm (0.
Acoustic Pulse Recognition Technology Table B-4 APR Specifications Input Method Finger, finger nail, solid stylus or gloved hand (cloth, leather or rubber) activation Mechanical Posi tional Accuracy 1% maximum error Resolu tion Accuracy Touchpoint density is based on controllers resolution of 4096 x 4096 Touch Activation Fo rce Typically 2 to 3 ounces (55 to 85 grams) Controller Board: USB 1.
Recognizing Preset Display Resolutions The display resolutions listed below are the most co mmonly use d modes and are set as factory defaults. This monitor automatically recognized these preset modes and they will ap pear properly sized and centered on the screen.
Energy Saver Feature When the monitor is in its normal operating mode, the monitor uses less than 21 watts and the Power light is gr een. The monitor also supports a reduced power state. The reduced power st ate will be entered into if the monitor detects the ab sence of eith er the horizo ntal sync signal and/o r the vertical sync signal.
C Agency Regulatory Notices Federal Communications Commission Notice This equipment has be en tested and found to comply with the limits for a Class B digita l device, pursuant to Part 15 of the FCC Rules. These limits are desi gned to pro vide reasonable p rotection against ha rmful interference in a residential installation .
Hewlett Packard Company P. O. Box 692000 , Mail Stop 5301 13 Houston, Texas 77 269-2000 Or, call 1-800 -HP-INVENT (1-800 474-68 36) For questions regarding this FCC declaration, contact: Hewlett Packard Company P. O. Box 692000 , Mail Stop 5101 01 Houston, Texas 77 269-2000 Or, call (281) 514-33 33 To iden tify this product , refer to the Par t, Series, or Mo del number fo und on the produ ct.
Hewlett-Packard GmbH, HQ-TRE, Herrenberger Strasse 140, 71034 Boeblingen, Germany German Ergonomics Notice HP products which be ar the “GS” approva l mark, when fo rming part of a system compr ising HP bran d computers, keyb oards and monitors t hat bear the “G S” approval mark, meet the applicable ergonomic requirements.
Product Environmental Notices Materials Disposal This HP product contains mercury in the fluorescent lamp in the display LCD that might require specia l handling at end-of-life. Disposal of this ma terial can be re gulated because of envi ronmental consideratio ns.
11363-2006 11363-2006 Turkey EEE Regulation In Conformity with the EEE Regulation EEE Yönetmeli ğ ine Uygundur ENWW Product Environmental Notices 31 .
D Native Resolution The native resolutio n of a monitor is the re solution level at which the LCD pa nel is designed to perform best. The native reso lution is 1024 x 768 for the 1 5 inch size. In almost a ll cases, screen images look best when viewed at their native resolution.
An important point after buying a device HP Compaq L5009tm (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought HP Compaq L5009tm yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data HP Compaq L5009tm - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, HP Compaq L5009tm you will learn all the available features of the product, as well as information on its operation. The information that you get HP Compaq L5009tm will certainly help you make a decision on the purchase.
If you already are a holder of HP Compaq L5009tm, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime HP Compaq L5009tm.
However, one of the most important roles played by the user manual is to help in solving problems with HP Compaq L5009tm. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device HP Compaq L5009tm along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center