Instruction/ maintenance manual of the product Steam Humidifiers Nortec
Go to page of 22
RESDELUX Steam Humidifiers Installation, Operation, Maintenance and Troubleshooting Guide IMPORTANT: READ AND SAVE THESE INSTRUCTIONS . This guide to be left with equipment owner.
Table Of Contents INSTALLATION 1 RECEIVING & UNPACKING EQUIPMENT ................................1 PRE-INSTALLATION CHECKPOINT ...................................1 HUMIDIFIER CONFIGURATION ......................................1 LOCATION & MOUNTING .
PRINCIPLE OF OPERATION .....................................1 2 FILL RATE ...............................................1 2 DRAIN TIME ..............................................1 2 RATED AMPERS ...........................................1 2 SHORT CYCLING .
INSTALLATION RECEIVING & UNPACKING EQUIPMENT 1. Check packing slip to ensure ALL material has been delivered. 2. All material shortages are to be reported to NORTEC within 48 hours from receipt of goods. NORTEC assumes no responsibility for any material shortages beyond this period.
6. DO NOT mount humidifier on hot surfaces. 7. DO NOT mount humidifiers in an area where freezing may occur. 8. DO NOT mount humidifiers on a vibrating surface. 10. DO NOT mount the humidifier to a duct or plenum. STEAM DISTRIBUTOR NOZZLE (in duct location) 1.
STEAM HOSE INSTALLATION 1. The length of the steam hose must not exceed 4’ (1.2m). 2. It must not be restricted in any way (i.e. - a kink resulting from a short radius bend). 3. Avoid condensate traps in the hose, see Figure #8. 4. Use wall clips (p/n 158-5001) to support the steam and condensate hoses and maintain 1” clearance from the wall.
4. Put the power leads from the blower pack through this opening as you position the blower pack on top of the RESDELUX humidifier 5. Push the blower pack forward until the locating tabs on the bottom of the blower pack with slots in the top of the RESDELUX push forward to engage.
NOTE: Improper wiring could damage the blower pack or RESDELUX PCB. 9. Remove the front door and service cover from the RESDELUX humidifier. 10. Connect the power leads for the blower pack to terminal P7 on the RESDELUX control board located next to the capacity adjustment potentiometer.
the flood level rim of a city-approved indirect waste receptor. ELECTRICAL ELECTRICAL REQUIREMENTS FOR PERMANENTLY CONNECTED RESDELUX 1. Check and ensure that available voltage and phase corresponds with operating voltage and phase of the humidifier as indicated on the humidifier nameplate label (see Figure #12).
current) across terminals 1 and 2 on the low voltage control terminal. Caution: This is the “common” wire from the transformer that is connected to the ground.
valves operation. Green and yellow lights flash during this time. If there is no call for humidity, the humidifier is standing by and green light flashes. When control loop is closed, the green light is steady on and the humidifier starts its operation.
(Life varies from 500 to 2000 operating hours, as illustrated in Figure #16.) The RESDELUX control board constantly monitors unit performance and will shut down the humidifier and alert the customer to change the cylinder. The yellow light will flash 4 times in sequence.
3. This color-coding must be adhered to when replacing cylinder plugs on pins. 4. The electrode plug with the orange wire always goes on the single pin surrounded by a plastic shoulder. 5. Ensure that cylinder plugs fit snugly on the pins. 6. If a cylinder plug becomes loose the cylinder harness must be replaced (P/N 158-1305 see parts list).
TROUBLESHOOTING PLEASE READ THIS SECTION BEFORE REFERENCING SPECIFIC DIAGNOSTIC MESSAGES. 1. Ensure the installation detail conforms with the recommendations contained in the Installation section of this manual. 2. Understanding the Principle of Operation is an asset when troubleshooting.
PROCEDURES AND TERMS USED IN DIAGNOSING PRINCIPLE OF OPERATION The conductivity of the water within the cylinder must be controlled in order for the humidifier to function properly. The fill and drain rates must be maintained. Filling too quickly can cause over-amping and automatic shutdown or blown fuses.
-1 3- 1 2 DRAIN VALVE FILL VALVE G G L1 L1 L1 GND N N N 110-120 V ac Hookup 110-120 V ac CORD CONNECTED G G L1 L2 L2 L2 L2 GND N 208-240 V ac Hookup STEP DOWN TRANSFORMER PRIMARY VOL TAGE EXTERNAL INTERNAL S 1.5 A ON/OFF CONTROLS L OW VOLT AGE TERMINAL STRIP WIRING DIAGRAM No.
-1 4- SUGGESTED WIRING INTERF ACE FOR F AN CONTROL USING RESDELUX HUMIDIFIER 3/1 1/02 W ALL (PN 1329102) OR DUCT (PN 1329108), MAKES ON F ALL IN HUMIDITY HUMIDIST A T HUMIDIST A T WIRED IN P ARALLEL W.
SPARE PARTS LIST AND EXPLODED VIEW - RESDELUX -1 5- Item Number Part Number Description 1 151-9002 Cylinder type 202 2 158-1820 Steam distributor kit 3 153-5062 Steam distributor 4 158-1830 Steam blow.
-1 6- 1 2 5 3 7 6 9 10 19 11 12 14 15 20 13e 4 21c 18 16 17 8 22 23 24 21b 21a 13a 13d 13b 13c 11 b 14a 11 a 8a 12a.
PERIODIC MAINTENANCE CHECKLIST PREVENTIVE MAINTENANCE AND SERVICE CHECK LIST FOR NORTEC’S RESDELUX Customer ______________________________________________________________ Address ___________________.
LIMITED WARRANTY NORTEC INDUSTRIES INCORPORATED and/or NORTEC AIR CONDITIONING INDUSTRIES LIMITED (hereinafter collectively referred to as THE COMPANY), warrant for a period of two years from date of .
Model #: Serial #: Cylinder #: Cylinder Last Replaced: _________________________ MTH/DAY/YR _________________________ MTH/DAY/YR _________________________ MTH/DAY/YR NORTEC AIR CONDITIONING INDUSTRIES LTD. 2740 Fenton Road Ottawa, ON K1T 3T7 Tel: (613) 822-0335 Fax: (613) 822-7964 A WMH COMPANY PRINTED IN CANADA NORTEC INDUSTRIES INC.
An important point after buying a device Nortec Steam Humidifiers (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Nortec Steam Humidifiers yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Nortec Steam Humidifiers - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Nortec Steam Humidifiers you will learn all the available features of the product, as well as information on its operation. The information that you get Nortec Steam Humidifiers will certainly help you make a decision on the purchase.
If you already are a holder of Nortec Steam Humidifiers, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Nortec Steam Humidifiers.
However, one of the most important roles played by the user manual is to help in solving problems with Nortec Steam Humidifiers. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Nortec Steam Humidifiers along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center