Instruction/ maintenance manual of the product ET2013IUTI-B014C Asus
Go to page of 42
English User Manual ET2013 Series MENU MODE.
English Cop yright © 2012 ASUST eK C OMPUTER INC. All Rights Reserved . No part of this manual, including the produc ts and software described in it, may be reproduced , transmitted, transcribed, sto.
English Contents C ontents .................................................................................................... 3 Notices .................................................................................................................
English Side views ............................................................................................................................................. 23 Using the touch screen ................................................................
English 5 All-in-one PC ET2013 Series Notices F ederal C ommunic ations C ommission Statemen t This device complies with P ar t 15 of the FCC Rules . Operation is subjec t to the follo wing two condit.
English 6 All-in-one PC ET2013 Series Canadian Department of Communications S tatement This digital apparatus does not ex ceed the Class B limits for r adio noise emissions from digital apparatus set out in the Radio Interference Regulations of the Canadian Department of Communications .
English 7 All-in-one PC ET2013 Series Wireless Oper ation Channel for Diff erent Domains N. America 2.412-2.462 GHz Ch01 through CH11 Japan 2.412-2.484 GHz Ch01 through Ch14 Europe ETSI 2.
English 8 All-in-one PC ET2013 Series F rance Restricted Wireless F requency B ands Some areas of France hav e a restricted frequency band. The worst case maximum authorized power indoors are: • 10mW for the entire 2.4 GHz band (2400 MHz–2483.5 MHz) • 100mW for frequencies between 2446.
English 9 All-in-one PC ET2013 Series NO DISASSEMBL Y The war ranty does not apply to the products that hav e been disassembled by users Lithium-Ion Battery W arning CA UTION : Danger of explosion if RT C (Real T ime Clock) battery is incorrectly replaced .
English 10 All-in-one PC ET2013 Series Global Envir onmental Regulation C ompliance and Declara tion ASUS follows the gr een design concept to design and manufacture our products, and makes sure that each stage of the product life cycle of ASUS product is in line with global envir onmental regulations.
English 11 All-in-one PC ET2013 Series Notes f or this manual T o ensure that y ou per form certain tasks properly , take note of the following symbols used throughout this manual. W ARNING: Vital information that you MUST follow t o prevent injury to yourself .
English 12 All-in-one PC ET2013 Series Saf ety infor ma tion Y our All-in-one PC ET2013 Series is designed and tested to meet the latest standards of saf ety for inf ormation technology equipment. However , to ensure y our safety , it is important that you read the follo wing safety instructions.
English 13 All-in-one PC ET2013 Series Sound Pressure W arning Excessiv e sound pressure from earphones or headphones can cause hearing damage or loss. Adjustment of the v olume control as well as the equaliz er to settings other than the center position may increase the earphones or headphones output v oltage and the sound pressure level.
English 14 All-in-one PC ET2013 Series W elcome Congra tulations on your purchase of All-in-one PC ET2013 Series. The following illustration displays the package contents of y our new product. If any of the f ollowing items is damaged or missing , contact your retailer .
English 15 All-in-one PC ET2013 Series Getting to kno w y our All-in-one PC F r ont view Refer to the f ollowing diagram to identify the c omponents on this side of the system.
English 16 All-in-one PC ET2013 Series 1 W ebcam LED Indica tes that the built-in webcam is enabled . 2 W ebcam T he built-in webcam with the built-in digital microphone allows y ou to star t video cha ts online.
English 17 All-in-one PC ET2013 Series ET2013IU Series 3 4 6 5 7 2 8 10 9 11 1.
English 18 All-in-one PC ET2013 Series 1 W ebcam LED Indica tes that the built-in webcam is enabled . 2 W ebcam T he built-in webcam with the built-in digital microphone allows y ou to star t video cha ts online.
English 19 All-in-one PC ET2013 Series R ear view Refer to the f ollowing diagram to identify the c omponents on this side of the system. 1 Stand A llows you to position the syst em upright. 2 K ensington® Lock port T he Kensington® lock por t allows the computer t o be secured using Kensington® c ompatible security produc ts.
English 20 All-in-one PC ET2013 Series 3 Pow er input T he supplied power adapter con ver ts AC pow er to DC power f or use with this jack. P ower supplied through this jack supplies pow er to the PC. T o preven t damage to the PC, always use the supplied po wer adapter .
English 21 All-in-one PC ET2013 Series 1 2 3 4 5 6 7 1 Stand A llows you to position the syst em upright. 2 K ensington® Lock port T he Kensington® lock por t allows the computer t o be secured using Kensington® c ompatible security produc ts.
English 22 All-in-one PC ET2013 Series 3 Pow er input T he supplied power adapter con ver ts AC pow er to DC power f or use with this jack. P ower supplied through this jack supplies pow er to the PC. T o preven t damage to the PC, always use the supplied po wer adapter .
English 23 All-in-one PC ET2013 Series Side views Refer to the f ollowing diagrams to identify the c omponents on both sides of the system. 1 Memory c ard reader (on selected model) Normally an external memory card reader must be pur chased separately in order to r ead memor y car ds.
English 24 All-in-one PC ET2013 Series Using the touc h scr een All-in-one PC brings digital life to y our finger tips. With a few touches , you can make All-in-one PC work at your c ommand.
English 25 All-in-one PC ET2013 Series Cleaning the touch screen The touch screen r equires periodic cleaning to achieve the best touch sensitivity . Keep the screen clean from f oreign objects or excessive dust accumula tion. T o clean the screen: • T urn off the system and disconnect the power cord from the w all.
English 26 All-in-one PC ET2013 Series P ositioning your All-in-one PC Placing on the desktop Place your A ll-in-one PC on a flat sur face such as a table or desk, and pull the stand open until pull the stand open until it snaps in place. Then, tilt the display panel to an angle of between 12 and 30 degrees from an upright position.
English 27 All-in-one PC ET2013 Series Installing the wall mount screw (optional) T o mount your A ll-in-one PC to the wall, purchase the optional wall mount screws and wall mount kit (pad and rack; VESA100, 100mm x 100mm). Install the wall mount screws accor ding to the follo wing instructions.
English 28 All-in-one PC ET2013 Series 4. Secure the four wall mount scr ews to the rear panel holes. 3. Remove the f our plastic caps, from the rear panel holes,.
English 29 All-in-one PC ET2013 Series 5. Mount the All-in-one PC onto a firm wall by applying a standar d wall mount kit (pad and rack) to the wall mount scr ews. Follo w the instructions described in the installation manual that came with your wall mount kit.
English 30 All-in-one PC ET2013 Series Setting up y our All-in-one PC Connecting the wired k eyboar d and mouse Connect the keyboard and mouse to the USB port on the rear panel ( 1 ). Y ou may also connect ou may also connect connect the keyboard and mouse to the USB port on the lef t side ( 2 ) if the keyboard and mouse cable is not long enough.
English 31 All-in-one PC ET2013 Series 2 3 1 P owering on the system Connect the supplied AC adapter t o the DC IN jack on the rear panel ( 1 2 3 ) and then press the P ower button on the fr ont panel ( 4 ) to turn on the system. 4 P owering off • T o put the system int o suspend mode, press the P ower button on the fr ont panel.
English 32 All-in-one PC ET2013 Series Calibr a ting the scr een All-in-one PC comes with the follo wing software tool that allows you t o adjust touch screen precision. 1. F rom the W indows® desktop , click Start > Con trol Panel > Har dware and Sound > T ablet PC S ettings and click Calibra te the screen for pen or touch input .
English 33 All-in-one PC ET2013 Series Conguring a wireless connection 1. Click the wireless network icon with an orange star in the W indows® Notification area.
English 34 All-in-one PC ET2013 Series Conguring a wired connection Using a sta tic IP 3 . Right-click Local Area Connection a n d select Properties . 2. Click Change adapter settings in the left pane. 1. Click the network icon with a yello w warning triangle in the Windows® Notification area and select Open Network and Sharing C enter .
English 35 All-in-one PC ET2013 Series 5. Select Use the following IP address . 6. Enter your IP addr ess , Subnet mask , and Default gatewa y . 7. If needed, enter the Pr eferred DNS server address. 8. After entering all the relat ed values, click OK to finish the configuration.
English 36 All-in-one PC ET2013 Series Using a dynamic IP (PPP oE) 1. Repeat steps 1–4 in the previous section. 2 Selec t Obtain an IP address automatically and click OK . (Continue the following steps if using PPP oE) 3. Return to the Network and Sharing Cen ter and then click Set up a new connection or network .
English 37 All-in-one PC ET2013 Series 5. Select Broadband (PPPoE) and click Next . 6. Enter your User name and, Passwor d, and Connection name. Click C onnec t .
English 38 All-in-one PC ET2013 Series 8. Click the network icon in the notification area and click the connection you just created . 9. Enter your user name and passw ord.
English 39 All-in-one PC ET2013 Series Conguring the audio output All-in-one PC supports different types of audio configurations. Set up the system using stereo speakers. Speaker c onfigurations Set up the system with the follo wing speaker configurations: A stereo speaker set is a left-right, two channel speaker system.
English 40 All-in-one PC ET2013 Series R eco v ering y our system Using the R eco v er y Par tition Reco vering the OS t o the F ac tor y Default Partition (F9 Recov er y) 1. Pr ess [F9] during bootup. 2. Select Windows setup [EMS Enabled] when this item appears and press [En ter].
English 41 All-in-one PC ET2013 Series Using the USB stor age device (USB R estor e) When the Recov er y P ar tition in your system is crashed , use the USB storage device t o restore the system to the factory default par tition or the fac tory environment data to the en tire hard disk.
English 42 All-in-one PC ET2013 Series Manufacturer ASUST ek C OMPUTER INC. Address , Cit y No . 150, LI-TE RD ., PEIT OU, T AIPEI 112, T AIW AN R.O.C Country T AIW AN Authorized Representa tive in Europe ASUS C OMPUTER GmbH Address , Cit y HARKORT STR.
An important point after buying a device Asus ET2013IUTI-B014C (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Asus ET2013IUTI-B014C yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Asus ET2013IUTI-B014C - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Asus ET2013IUTI-B014C you will learn all the available features of the product, as well as information on its operation. The information that you get Asus ET2013IUTI-B014C will certainly help you make a decision on the purchase.
If you already are a holder of Asus ET2013IUTI-B014C, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Asus ET2013IUTI-B014C.
However, one of the most important roles played by the user manual is to help in solving problems with Asus ET2013IUTI-B014C. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Asus ET2013IUTI-B014C along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
