Instruction/ maintenance manual of the product Full Weather Station with Radio Controlled Clock Oregon Scientific
Go to page of 26
EN Full Weather St ation wit h Radio Controlled Cloc k (Model #: PS- L0 1 / PS -L0 1U ) User Manual PS-L01_GB-final 8/8/03, 11:35 AM 1.
EN PS-L01_GB-final 8/8/03, 11:35 AM 2.
EN 1 T ABLE OF CONTENTS About this guide ........................................................ 2 Product overview ....................................................... 3 Getting started .......................................................... 8 Batteries .
EN 2 ABOUT THIS GUIDE Congratulations on your selection of the Philippe Starck with Oregon Scientific Full W eather Station with Radio Controlled Clock (PS-L01 / PS-L01U).
EN 3 PRODUCT OVERVIEW TOP VIEW DESCRIPTIONS 1. Snooze / Light button ( → 11, 17) 2. Light sensor ( → 17) 1 2 PS-L01_GB-final 8/8/03, 11:35 AM 5.
EN 4 LCD DISPLA Y DESCRIPTIONS 1. Low battery icon ( → 8) 2. Clock ( → 10) 3. Barometer ( → 13) 4. Weather forecast ( → 14) 5. Moon phase ( → 12) 6.
EN 5 BACK VIEW BUTTON DESCRIPTIONS 1. Select – switch modes / change settings 2. Up – increase setting / activate auto-synch ( → 10) 3. Down – decrease setting / deactivate auto-synch ( → 10) 4. Alarm – activate / deactivate alarm ( → 11) 5.
EN 6 BOTTOM VIEW DESCRIPTIONS 1. Battery compartment ( → 8) 2. Light sensitivity knob ( → 18) 3. Reset button ( → 8, 18) 4. Backlight switch ( → 17) 5.
EN 7 REMOTE UNIT DESCRIPTIONS 1. T emperature / T rend display 2. Low battery icon 3. Humidity / T rend / Comfort Level display 4. ° C / ° F switches 5.
EN 8 GETTING ST ARTED BA TTERIES Batteries for the remote and main units are supplied with this product. Replace them whenever the low battery signal ( ) displays. Remove the battery compartment lid on the bottom of the main unit, and insert the batteries.
EN 9 CHANGE SETTINGS Press and hold SELECT for 2 seconds. Then, press UP or DOWN to change each setting. Press SELECT to switch options. REMOTE UNIT SET UP Up to 3 remote units can be used with this product to monitor outdoor temperature and humidity .
EN 10 CLOCK This product can automatically synchronize the date and time with official time-keeping organizations in Frankfurt, Germany (PS-L01) or Rugby , England (PS-L01U). When the unit is within 1500 km (932 miles) of a RF signal, the reception icon will blink during reception.
EN 11 SET OR CHANGE THE CLOCK 1. Press SELECT to switch to the Clock Mode. The time will flash. 2. Press and hold SELECT for 2 seconds to enter the setting mode. 3. Select the 12/24-hour format, hour , and minute. Press UP or DOWN to change the setting.
EN 12 T o turn the alarm off completely (deactivate it for the next day), press ALARM . CALENDAR SET DA TE Clock auto-synchronization must be deactivated before you manually set the date. ( → 10) 1. Press SELECT several times until the calendar area flashes.
EN 13 BAROMETER This product tracks barometric pressure changes over the past 24 hours to provide the weather forecast ( → 14) and a trend line showing the direction of barometric change. Barometric changes are measured by the main (indoor) unit. BAROMETRIC TREND The barometric trend arrow for the last 30 minutes is always displayed.
EN 14 SET UNIT AND AL TITUDE Y ou can set the unit of measurement (mb/hPa or inHg) and altitude. Setting the altitude allows the product to take more accurate barometric measurements. 1. Press SELECT 2 times until the Barometer Area flashes. 2. Press and hold SELECT for 2 seconds.
EN 15 Outdoor measurements are collected by the remote unit. T emperature is give at the top; humidity is below . VIEW MIN / MAX / CURRENT MEASUREMENTS Press SELECT 3 times until the T emperature and Humidity Areas flash. Press UP or DOWN to scan the readings.
EN 16 NO TE Signals from household electrical appliances such as doorbells and home security systems can cause temporary reception failures between the indoor and outdoor units. This is normal and does not affect the general performance of the product.
EN 17 TRENDS The trend arrow for the last 30 minutes always displays. Indoor and outdoor temperature and humidity trends are shown separately . SET UNIT While in T emperature / Humidity Mode, press SELECT for 2 seconds. Press UP or DOWN to switch between ° C and ° F .
EN 18 2. Move it to the “AUTO” position to enable continuous backlight controlled by light intensity . When activated, the backlight will be on whenever the unit perceives that the room is dark. 3. The Light Sensitivity knob is located in the battery compartment.
EN 19 W ARNINGS This product is designed to give you years of service if handled properly . Obser ve the following guidelines: • Never immerse the unit in water . This can cause electrical shock and damage the unit. • Do not subject the main unit to extreme force, shock, or fluctuations in temperature or humidity .
EN 20 Problem Symptom Remedy Clock Cannot auto- synchronize 1. Remove batteries. 2. Press RESET . All memory items will return to default. 3. Replace batteries.
EN 21 SPECIFICA TIONS Main unit dimensions L x W x H 181 x 45 x 185.3 mm (7.1 x 1.77 x 7.3 inches) W eight 894 grams with battery Remote unit dimensions L x W x H 75 x 35 x 78.
EN 22 Remote Unit: -20 ˚C to 60 ˚C (-4 ˚F to 140 ˚F) Resolution 0.1 ° C (0.2 ° F) Comfort 20 ° C to 25 ° C (68 ° F to 77 ° F) (see also, Relative humidity) Memory Minimum / maximum T rend +/- 0.
EN 23 Channel No. 1, 2, or 3 Unit ° C or ° F Radio-controlled clock Synchronization Auto or disabled Clock display HH:MM:SS Hour format 12hr AM/PM (MSF format) 24hr (DCF format) Calendar DD/MMM; wee.
EN R TT&E Compliant Countries: All EC Countries, Switzerland CH , and Norway N © 2003 Oregon Scientific. All rights re served. EC-DECLARA TION OF CONFORMITY This product contains the approved tra.
An important point after buying a device Oregon Scientific Full Weather Station with Radio Controlled Clock (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Oregon Scientific Full Weather Station with Radio Controlled Clock yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Oregon Scientific Full Weather Station with Radio Controlled Clock - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Oregon Scientific Full Weather Station with Radio Controlled Clock you will learn all the available features of the product, as well as information on its operation. The information that you get Oregon Scientific Full Weather Station with Radio Controlled Clock will certainly help you make a decision on the purchase.
If you already are a holder of Oregon Scientific Full Weather Station with Radio Controlled Clock, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Oregon Scientific Full Weather Station with Radio Controlled Clock.
However, one of the most important roles played by the user manual is to help in solving problems with Oregon Scientific Full Weather Station with Radio Controlled Clock. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Oregon Scientific Full Weather Station with Radio Controlled Clock along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
