Instruction/ maintenance manual of the product 2017P60 RS-232 to 60mA Patton electronic
Go to page of 7
USER MANUAL MODEL 2017P RS-232 to 20mA and MODEL 2017P60 RS-232 to 60mA Current Loop Converters 07M2017P-E Doc# 073051UE Revised 5/7/96 SALES OFFICE (301) 975-1000 TECHNICAL SUPPORT (301) 975-1007.
1.0 W ARRANTY INFORMA TION Patton Electronics warrants all Model 2017P components to be free from defects, and will—at our option—repair or replace the product should it fail within one year from the first date of shipment.
3.0 CONFIGURA TION The Model 2017P is designed to be easy to use. There are no internal jumpers or DIP switches to set, so there is no need to open the case to configure the unit (you may need to open the case for wire connection—refer to Section 4.
Once the unit has been opened, you will be able to see the terminal blocks located at the rear of the PC board. 2. Strip the outer insulation from the twisted pairs about one inch from the end. 3. Strip back the insulation on each of the 2 twisted pair wires about .
9. Insert the strain relief assembly with the wire going through it into the slot in the bottom half of the modem case and set it into the recess in the case. 10. BEND the top half of the case as necessary to place it over the strain relief assembly .
APPENDIX A SPECIFICA TIONS T ransmission Line : 19 to 26 A WG twisted pair Range : 4 miles on 24 A WG twisted pair Interfaces : Asynchronous, EIA RS-232, CCITT V .24 full duplex, 20mA current loop (Model 2017P60 connects to 60mA current loop) Data Rates : 0 - 1 15.
APPENDIX C BLOCK DIAGRAM 11.
An important point after buying a device Patton electronic 2017P60 RS-232 to 60mA (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Patton electronic 2017P60 RS-232 to 60mA yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Patton electronic 2017P60 RS-232 to 60mA - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Patton electronic 2017P60 RS-232 to 60mA you will learn all the available features of the product, as well as information on its operation. The information that you get Patton electronic 2017P60 RS-232 to 60mA will certainly help you make a decision on the purchase.
If you already are a holder of Patton electronic 2017P60 RS-232 to 60mA, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Patton electronic 2017P60 RS-232 to 60mA.
However, one of the most important roles played by the user manual is to help in solving problems with Patton electronic 2017P60 RS-232 to 60mA. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Patton electronic 2017P60 RS-232 to 60mA along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
