Instruction/ maintenance manual of the product 4411-0019 Princeton
Go to page of 16
P/N 4411-0019 manual Coolant Operation Cir culator CC-100 Manual Version 1 Revision B July 1, 1998 .
.
iii Table of Contents Chapter 1 Introduction ........................................................................................ 5 Description .......................................................................................................
.
5 Chapter 1 Introduction Description The Model CC-100 Coolant Circulator is a universal water-to-air heat exchanger. It transfers heat from any heat source into the air. It was designed primarily for removing heat from thermoelectrically cooled CCD cameras.
6 CC-100 Coolant Circulator Manual Version 1.B Cooling Capacity Temperature rises approximately 0.03°C per watt (3.4 btu/hr). Based on a typical flow rate of between 0.5 (0.47 liter) to 1 quart (0.95 liter) per minute and a thermal load of 100 watts (341 btu/hr).
7 Chapter 2 Warnings Introduction This chapter contains cautions and notes concerning initial setup and operation of your system. Of course, reading this section should not replace reading the entire manual.
8 CC-100 Coolant Circulator Manual Version 1.B Never allow coolant to freeze. For storage, shipping and operating, a mixture of water/antifreeze or equivalent should be used to prevent freezing and corrosion. Any commercial brand antifreeze, recommended for automotive use, may be used in the CC- 100.
9 Chapter 3 Installation Inspection When unpacking the CC-100, it should be inspected for any obvious shipping damage. Any shipping damage noted should be reported without delay to both the carrier and to Princeton Instruments, Inc., before operating the system.
10 CC-100 Coolant Circulator Manual Version 1.B secure it with the eight screws and washers removed above. Installation is now complete..
11 Chapter 4 Maintenance Air Filter The frequency of cleaning depends on the environment around the CC-100. Usually, whenever the velocity of air coming out of the CC-100 decreases, it is time to clean the filter. Another indication is the rise in the outlet temperature above ambient.
12 CC-100 Coolant Circulator Manual Version 1.B Schematic Diagrams Figure 1. Flow diagram. Figure 2. 115 V Chassis Wiring diagram..
Chapter 4 Tips and Tricks 13 Figure 3. 100 V Chassis Wiring diagram..
14 CC-100 Coolant Circulator Manual Version 1.B Figure 4. 230 V chassis wiring..
15 Warranty and Service Warranty This equipment is warranted to be free from defects of material and workmanship. It is sold subject to the mutual agreement that the liability of Princeton Instruments, Inc.
16 CC-100 Coolant Circulator Manual Version 1.B well as all charges incurred to perform the repairs. In this case, the customer can decide the insurance value. International customers should contact your local manufacturers representative or distributor for repair information.
An important point after buying a device Princeton 4411-0019 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Princeton 4411-0019 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Princeton 4411-0019 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Princeton 4411-0019 you will learn all the available features of the product, as well as information on its operation. The information that you get Princeton 4411-0019 will certainly help you make a decision on the purchase.
If you already are a holder of Princeton 4411-0019, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Princeton 4411-0019.
However, one of the most important roles played by the user manual is to help in solving problems with Princeton 4411-0019. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Princeton 4411-0019 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
