Instruction/ maintenance manual of the product S2000 AutoFlo
Go to page of 12
ELECTRONIC STEAM UNIT - POWER HUMIDIFIER MODELS S2000 AND S2020 FOR GAS OR OIL FORCED AIR FURNACES, HEA T PUM PS A ND ELECTRIC FURNACES The AutoFlo Residential Power Humidifier you have purchased has been designed to be simple to Install, Operate and Maintain.
SIMPLIFIED INST ALLA TION INSTRUCTIONS DET AILED INST ALLA TION INSTRP4.56603 0.000010000 TD(L)Tj8.5660 0.0000 TD701 I3 IION.
6. W ATER SUPPL Y - Required Criteria 9. WIRING THE STEAM HUMIDIFIER IMPORT ANT: Dedicated fused circuits of the pr oper voltage and current ratings must be provided. All wiring must conform to local and national codes. 7. M OUNTING THE STEAM HUMIDIFIER 8.
10. SETTING THE HUMIDIST AT Connect field wiring as shown in Figures 5 or 6. It is recommended that humidistat settings of 30-40% not be exceeded. If condensation is noticed on windows during very cold outside temperatures, the humidistat setting should be lowered.
11. INITIAL STAR T -UP - SEQUENCE OF OPERATION and SER VICE “LED” INDICAT ORS 12. OPERATING SEQUENCE Once the Steam Humidifier has been installed and the water, humidistat and blower interlock connections completed, the humidifier may be initially started.
14. SERVICE INDICA TORS Seven LED lamps provided on the front panel indicate the functional status of the humidifier as shown in Figure 7 below. 6 A. L. M. N. O. B. C. D. E. F. G. H. I. J. K. Unplug the power cord from the 120 volt source for S2000 (240 volt for S2020) and allow the water to cool for at least 30 minutes prior to removal.
7 A. G. B. C. D. E. F. The green "Power" light does not blink off and on. 1. The S2000 is not connected to an active 120 V AC 15 Amp power source. (S2020, 240 V AC, 10 AMP). 2. Call the Technical Support Hotline. The "HEATER" LED does not illuminate.
15. SERVICE AND REPLACEMENT P ARTS CONTROLS INC. 385 Highway 33 Englishtown, NJ 07726 www.ew ccontrols.com e-mail: autoflo@ewccontrols.com T el. (800) 446-3110 Fax : (732) 635-8646 8 ITEM 1 120 VOLT H.
CONTROLS INC. 385 Highway 33 Englishtown, NJ 07726 www.ew ccontrols.com e-mail: autoflo@ewccontrols.com T el. (800) 446-3110 Fax : (732) 635-8646 T ech. (800) 526-4048 FIG. 8 9 DRAIN COCK VAL VE P/N 094020A0055 "T" ADAPTER, 1/4" NPT P/N 094021A0038 OVERFLOW TUBE, .
AUTOFLO HUMIDIF IER Z100 ASSEM BLY INSTALLATION INSTRUCTIONS & OWNER'S MANUAL Z100 REPLACEMENT INSTRUCTIONS SUPPLEMENT TO THE AUTOFLO ELECTRONIC STEAM POWER HUMIDIFIERS MODEL # S2000 AND S2020 APPLICA TION NOTE AN 131 The AUTOFLO steam humidifier now comes equipped with a factory installed Z100, which ac ts as a sacrificial metal.
C E W CONTROLS INC. Excellence W ithout Compromise R APPLICA TION NOTE AN 147 F AN F AILURE SAFETY LOCK-OUT CIRCUIT “Field Provided” EWC Controls Inc.
“S” series AutoFlo Steam Humidifier IMPORT ANT NOTES: EWC Controls Inc. 385 Highway 33 Englishtown, NJ 07726 800-446-31 10 732-446-31 10 F AX 732-446-5362 LOCATION: Installing the steam unit in the attic is NOT recommended.
An important point after buying a device AutoFlo S2000 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought AutoFlo S2000 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data AutoFlo S2000 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, AutoFlo S2000 you will learn all the available features of the product, as well as information on its operation. The information that you get AutoFlo S2000 will certainly help you make a decision on the purchase.
If you already are a holder of AutoFlo S2000, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime AutoFlo S2000.
However, one of the most important roles played by the user manual is to help in solving problems with AutoFlo S2000. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device AutoFlo S2000 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center