Instruction/ maintenance manual of the product 41BT Azden
Go to page of 11
UHF PERFORMANCE SERIES TRUE DIVERSITY SYSTEMS AZDEN CORPORA TION 147 New Hyde Park Road Franklin Square, NY 1 1010 516.328.7500 vox 516.328.7506 fax azdenus@aol.
Thank you for purchasing AZDENS PERFORMANCE SERIES wir eless system. UHF wireless systems yield a better signal to noise ratio and improved fr equency response over VHF systems. The UHF band is less crowded than VHF thus giving you less likelihood of interfer ence.
(5) 12 V olt Input Plug the supplied AC adapter into the 12 volt input on the receiver then into an AC electrical outlet. Use only the adapter supplied, as other adapters may damage the receiver . (6) Output Adjustment Rotate this knob clockwise to increase, or counterclockwise to decrease volume level.
The following feature is for the 41 1DRH only . (12) Squelch adjust This adjusts the point at which the receiver will shut off or squelch the incoming radio signal when it becomes too weak.
T ransmitter Descriptions : 41HT Handheld microphone transmitter with 63 on-board user selectable UHF frequencies. Ideal for all vocal applications. The 41HT3 is identical in RF performance. It features an Audix microphone element. (1) T o install batteries, turn the bottom half of the mic case counter-clockwise until it is completely off.
41BT body-pack transmitter with 63 on-board user selectable UHF frequencies. Ideal for use with lavaliere and headset microphones. The MP-1 instrument cable will also allow you to use the 41BT with electric guitars and basses. Please note: For use with instruments the gain structure of the 41BT must me modified at the factory .
41XT plug-in XLR transmitter with 63 on-board user selectable UHF frequencies. Ideal for use with dynamic microphones with XLR output. (1) Open the battery compartment lid by sliding it down and raising it (2) Insert one fresh alkaline 9-volt battery into the compartment.
(6) LED INDICA T ORS The POWER LED turns green when power is turned On or red if battery level is low . If this LED lights up red replace the battery . The AF PEAK LED lights up if the input level is set to high, indicating the onset of distortion.
41BT with Lavaliere or Headset: W ith someone talking into the microphone, turn the volume on the mixer or amplifier to the desired level. If there is too much, or not enough gain, lower or raise the volume on the receiver . If the sound is distorted, lower the input gain on the transmitter .
Specifications Overall: Frequency Range: UHF 63 ch.(793-806MHz) Frequency Response: 20Hz to 20kHz Audio Distortion: less than 1% Dynamic Range: better than 100dB S/N Ratio: better than 95dB Operating T emperatures: 0 to 45 Operating Range: 100m under ideal conditions Oscillator: PLL synthesized T one Squelch Frequency: 32.
41HT/41HT3 T ransmitter : T ype of Emission: FM Antenna: Internal Antenna Microphone Unit: Unidirectional Dynamic RF Output Power: 10m W (50mW MAX) Input Impedance: 8K Audio adj Range: m/2 Battery:2 1.
An important point after buying a device Azden 41BT (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Azden 41BT yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Azden 41BT - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Azden 41BT you will learn all the available features of the product, as well as information on its operation. The information that you get Azden 41BT will certainly help you make a decision on the purchase.
If you already are a holder of Azden 41BT, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Azden 41BT.
However, one of the most important roles played by the user manual is to help in solving problems with Azden 41BT. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Azden 41BT along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
