Instruction/ maintenance manual of the product ADA151M U-Line
Go to page of 20
® COMBO ® MODELS & MANU AL DEFROST ICE MAKERS CO29 CO1175 USE AND CARE GUIDE AD A15IM BI95 BI2115 BI98 U-LINE.COM The Built-In Under counter Leader Since 1962 SP18.
Introduction to U-Line FOR PRODUCT ASSIST ANCE, CALL 1-800-779-2547 MIL WAUKEE, WI U.S.A. Serial/Serie: Model/Modele: HIGH SIDE DESIGN PRESSURE 300 PSI LOW SIDE DESIGN PRESSURE 140 PSI REFRIGERA TOR AND/ BTL LISTED 674R OR FREEZER HOUSEHOLD U C L R US www .
U-Line Use and Care Table of Contents 1 i - Introduction .......................... .................... ..................... .......................... ................. ................... .................... ............ i Read and save this Use and Care Guide.
2 U-Line Use and Care Guide.
U-Line Safety Precautions 3 IMPOR T ANT IMPOR T ANT • PLEASE READ all instru ctions befor e installing, operating, or servicing the appliance. • Proper installation pr ocedures must be follo wed when completing an instal lation or relocation of a unit.
4 U-Line Combo Model and Ice MakerProduct Fea tures 4 Pr oduct Featur es Ice Mak ers Featur e: High ice production and storage. AD A15IM, BI2115 and BI98 models pr oduce up to 25 pounds of ice per da y and store 2 5 pounds. BI95 and SP18 models pr oduce up to 23 pounds of ice per da y and store 12 pounds.
U-Line Product Operation 5 OFF ON 1 Pr oduct Operation T o turn the unit on or off: Press the r ocker sw itch located below the temperature contr ol dial in the center of the grille (2), inside the door on t he fro nt panel, or behind the grille.
6 U-Line Product Operation T o check the actual pr oduct temperatur e in the unit. 1. Partially fill a plastic (non breakable) b ottle with water . 2. In sert an accurate thermometer . 3. Tighten the bottle ca p secur ely . 4. Place the bottle in the de sire d area f or 24 hours.
U-Line Ice Makers 7 OFF ON 2 1 6I c e M a k e r Ice Mak er Adjustment Ice Cube Thickness Adjustment. Inter val - A s Required On ice mak er equipped models, adjust the cube size by changing water amount injected into the ice mak er assembly as follows: T o turn off ice production: Raise the bin arm into an upright and lock ed position.
8 U-Line Combo® Models and Ice Mak ers Maintenance 1 7 Maintenance For Models with adjustable lev eling feet: 1. Use a level to check the levelness of the uni t from fr ont to back and from side to side . Place th e le ve l along top edge and sid e edge as show n (1).
U-Line Combo® Models and Ice Mak ers Maintenance 9 1 2 4 Remo ving and Installing Door Shelves For models equpped with door shelv es: To r e m o v e t h e d o o r s h e l f : 1. Grasp shelf in center , and lift until the she lf notches (1) clear the pins (2).
10 U-Line Standard Door Alignment and Reversal 8 Standard Doors Door Alignment and Adjustment Align and adjust the door if it is not lev el, or is not sealing prope rly . If the door is not sealed the unit ma y not cool properl y , or excessiv e fr ost ma y form in the interior .
U-Line Standrd Door Alignment and Reversal 11 Install bottom hing e: 1. If you ha ve a plate hinge, reorient the pivot scr ew so it pr otrudes the opposite dir ection form the hinge. Remove the pivot scre w from the hinge. T urn the plate ov er and reinstall the scre w .
12 U-Line Self-Closing Door Alignment and Reversal 1/8" (3.175 mm) 1 23 4 9 Self-Closing Doors Door Alignment and Adjustment Align and adjust the door if it is not lev el, or is not sealing prope rly . If the door is not sealed the unit ma y not cool properl y , or excessiv e fr ost ma y form in the interior .
U-Line Self-Closing Door Alignment and Reversal 13 3 4 ULI 5 NO TCH 1 2 T o re verse the door: Remo ve door : 1. Hold door to k eep it fr om falling. 2. Remove hinge screw pin (1) from top hinge using a Phillips scre wdriver . 3. Remov e door b y tilting f orwar d and liftin g door off bo ttom hinge closer inser ts.
14 U-Line Combo® Models and Ice Mak ers Cleaning To d e f r o s t : 1. Disconnect po wer to the unit. 2. For combo models remov e all products fr om the interior . 3. Remove ice buck et and discard ice. 4. Plac e tow el or other absorbent materialon bottom of ice bin.
U-Line Combo® Models and Ice Mak ersCleaning 15 Condensor Cleaning Interv al - Every Six Months T o maintain ope rational effici ency , keep the fr ont grille free of dust and lint, and clean the condenser ev er y three months. Depending on envir onmental conditions, mor e or less fr equent cleaning ma y be necessary .
16 U-Line Combo® Models and Ice Mak ers Service 11 Ser vice Prob lem P ossible Ca use and Remedy Interior Light Does Not Illuminate. The light bulb ma y be defective.(See MAINTENA CE) Light Remains on When Door is Closed. Adjust light actuator bracket ob bottom of doo r .
U-Line Warranty 1. U-Line Corporation ("U- Line") warrants each U-Line product to be free from defects in materials and workmanship for a period of one year from the date of purchase.
® ABOUT U-LINE Building on 45 y ears, U-Line has captivated those with an a ppreciation f o r the finer things with exceptional design, inspired inno vations and atte ntion to e v en the smallest details.
An important point after buying a device U-Line ADA151M (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought U-Line ADA151M yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data U-Line ADA151M - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, U-Line ADA151M you will learn all the available features of the product, as well as information on its operation. The information that you get U-Line ADA151M will certainly help you make a decision on the purchase.
If you already are a holder of U-Line ADA151M, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime U-Line ADA151M.
However, one of the most important roles played by the user manual is to help in solving problems with U-Line ADA151M. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device U-Line ADA151M along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
