Instruction/ maintenance manual of the product Liquid Propane Gas Weber
Go to page of 36
® 55057 04/10/00 Liquid Pr opane Gas A081.c B054.c C052.b D002.e S IL VER – B G ENESIS ® S IL VER – B G ENESIS ® Gas Grill Owners Guide D ANGER If y ou smell gas: 1. Shut off gas to the appliance. 2. Extinguish an y open flames. 3. Open lid 4.
A-2 D ANGER F ailure to follo w the Dang er s, W arnings and Cautions contained in this Owner ’ s Manual may result in serious bodil y injury or death, or in a fire or an e xplosion causing damage to pr oper ty . W ARNINGS Do not store a spare or disconnected liquid pr opane cylinder under or near this barbecue.
A-3 Weber-Stephen Products Co. (W eber) hereby warrants to the ORIGINAL PURCHASER of this Weber Gas Grill that it will be free of defects in material and workmanship from the date of purchase as follows: when assembled and operated in accordance with the printed instructions accompanying it.
A-4 Danger & W arnings ................................ A-2 W arranty ................................................. A-3 General Instructions ............................... A-5 Exploded View ....................................... A-6 Parts List .
A-5 General Instructions Y our Weber Gas Barbecue is a portable outdoor cooking appliance. With the Weber Gas Barbecue you can grill, barbecue, roast and bake with results that are difficult to duplicate with indoor kitchen appliances. The closed lid and Flavorizer ® Bars produce that “ outdoor ” flavor in the food.
A-6 Genesis Silv er-B LP 5 1 2 3 4 6 7 8 9 10 11 12 14 13 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 32 45 46 48 49 51 50 47 52 53 54.
A-7 1. Hinge Pin 2. Left Endcap 3. Shroud 4. Handle 5. W arm-Up Basket 6. W arming Rack 7. Cooking Grate 8. Flavorizer Bar 9. Cooking Box 10. 1/4-20 keps nut 11. Slide Out Bottom T ray 12. Catch pan holder 13. 1/4-20 x 1/2 inch bolt 14. Left T rim piece 15.
A-8 © 1999 Weber-Stephen Products Co., W eber , the silhouette, and the kettle configuration are registered trademarks of Weber-Stephen Products Co., 200 East Daniels Road, Palatine, IL, 60067-6266, U.S.A. This product is covered by one or more United States patents and patents in other nations globally .
A-9 Y ou will need: Screwdriver Phillips screwdriver Hammer 7/16 open-end or an adjustable wrench Pliers Block of wood Lid - 1 Cooking Box - 1 Cooking grates - 2 Control panel - 1 Left Frame - 1 Right.
A-10 Cylinder Panel - 1 Bottom tray - 1 Catch Pan Holder - 1 Catch-Pan - 1 Disposable Drip Pans - 2 Manifold Support Bracket - 1 Thermometer - 1 Wheels - 2 Casters - 2 Liquid Propane Cylinder - 1 Fuel.
B-1 Assemb l y Instructions (1) (2) Assemble wheel frame Y ou will need: axle rod, two wheel hubcaps, tw o wheels, wheel fr ame, hammer and a b lock of wood. Place one end of the axle rod on the block of wood (or other protected surface). T ap one hubcap onto the end of the axle rod.
B-2 Complete frame assembl y Y ou will need: par tial frame assembly , two frame connectors, f our 2 inch bolts, f our nylon washers and a 7/16 inch or adjustab le wrench. Hold one frame connector between the caster frame and wheel frame. Add the nylon washer to the bolt.
B-3 Insert casters Y ou will need: frame assembly and tw o casters. Push the casters firmly into the inserts in the ends of the caster frame. Add cooking bo x (assembly) Y ou will need: frame assembly , cooking bo x (assembly), 2 inch bolt, n ylon washer , keps n ut, pliers and a 7/16 inch or adjustable wrench.
B-4 (1) (2) Install manif old brac ket Y ou will need: manifold brac ket. Hook the bracket(2) onto the manifold at the center burner valve. Place your hand underneath the bracket. Lift the manifold, bracket and cooking box slightly , then hook the tab of the bracket onto the frame brace(1).
B-5 (1) (2) (3) Add fuel gauge Y ou will need: fuel gauge, two wing n uts and two n ylon washers . 1) Slip the bolts on the back of the fuel gauge through the two small holes in the cylinder panel. 2) Add washers to the bolts, then wing nuts, and tighten with your fingers.
B-6 Fill liquid pr opane cylinder Note - The liquid propane cylinder manuf acturer is responsible f or the materials, workmanship and perf or mance of the cylinder . If the cylinder has a def ect, malfunctions, or you ha v e a question regarding the cylinder , call the cylinder manuf acturer ’ s customer ser vice center .
B-7 Check that all b urner valves are off Y ou will need: burner control knobs. V alves are shipped in the OFF position, but you should check to be sure that they are turned OFF . Put the knob on each valve. Check by pushing down and turning clockwise.
B-8 Check f or gas leaks D ANGER Do not use an open flame to chec k for gas leaks. Be sure there are no sparks or open flames in the area while y ou check f or leaks. Sparks or open flames will result in a fire or e xplosion which can cause serious bodily injury or death and damage to pr oper ty .
B-9 (1) (2) (1) Install the slide out bottom tray Y ou will need: the slide out bottom tra y(1), catch pan holder(2), catch pan and one disposable drip pan. Hook the ends of the catch pan holder into the hole in the slide out bottom tray . The fr ont of the catch pan holder must be on the same side as the finger grip(1) of the bottom tray .
C-1 Installing Features (1) Install the right end trim piece with tool holders and right swing-up w ork surface Y ou will need: Right tr im piece with tool holders , r ight s wing-up wor k surf ace, s wing-up work surface rod, one 1/2 inch bolt, one nylon w asher and a wrench 1.
C-2 (2) (1) View from underneath View inside of control panel 4.) While holding swing-up work surface in position, insert the other end of the swing-up work surface rod into the right end trim piece (1).
C-3 T o raise swing-up work surface: Lift table all the way up and slide it to the left, then lower table until you feel it lock in the up position. T o lower swing-up work surface: Lift table up until it disengages and slide it to the right.
C-4 4.) While holding swing-up work surface in position, insert the other end of the swing-up work surface rod into the left end trim piece. Push the trim piece into the frame. 5.) Add a washer to the bolt and insert it through the hole in the frame and the hole in the trim piece.
C-5 Install contr ol panel and burner contr ol knobs Y ou will need: control panel, two Phillips screws/ washers , a Phillips scre wdriver , and burner control knobs. 1) Set the control panel in place over both frame braces. Hold the Crossover Ignition button up while setting the control panel in place.
C-6 Install the bottom shelf Y ou will need: Bottom shelf . Set the bottom shelf in place between the two frame connectors underneath the cooking box. Install the thermometer Y ou will need: Ther mometer . Insert the thermometer into its holder on the right side of the lid.
D-1 Lighting Summary lighting instructions are on the control panel. m D ANGER F ailure to open the lid while igniting the barbecue’ s burners, or not waiting 5 min- utes to allow the gas to c lear if the barbe- cue does not light, may result in an e xplo- sive flame-up which can cause serious bodily injury or death.
D-2 To Extinguish Push down and turn eac h burner contr ol knob cloc kwise to the OFF position. T urn gas supply OFF at the source. Manual Lighting m D ANGER F ailure to open the lid while igniting th.
D-3 Cooking m W ARNING: Do not mo ve the Weber Gas Barbe- cue when operating or while barbecue is hot. Y ou can adjust the FRONT and BACK burners as desired. The control settings: High (H), Medium (M), Low (L), or Off (O) are described in your W eber cookbook.
D-4 Refilling the Liquid Pr o- pane Cylinder We recommend that you refill the LP cylinder before it is completely empty . Remov al of the LP cylinder 1) Close cylinder valve (turn clockwise). 2) Unscrew regulator coupling by turning counter- clockwise, by hand only .
D-5 7) Check for leaks by wetting the fitting with the soap and water solution and watching for bubbles. If bubbles form, or if a bubble grows, there is a leak. Liquid Propane Cylinder The liquid propane cylinder manufacturer is respon- sible for the materials, workmanship and performance of the tank.
D-6 Safe handling tips f or Liquid Pr opane Gas Cyl- inder s ■ Liquid Propane (LP) gas is a petroleum product as are gasoline and natural gas. LP gas is a gas at regular temperatures and pressures. Under moderate pressure, inside a cylinder , LP gas is a liquid.
D-7 Annual Maintenance After a period of nonuse, we recommend that you perform the following maintenance procedures for your safety . m W ARNING: Chec k the hose before eac h use of the barbecue for nic ks, cracking, abrasions or cuts. If the hose is found to be damaged in an y way , do not use the barbecue.
D-8 General Maintenance Weber Spider Stopper™ Guards Y our Weber Gas Barbecue, as well as any outdoor gas appliance, is a target for spiders and other insects. They can nest in the venturi section (V enturi(1), air shutter(2), venturi fin(3) ) of the burner tubes.
D-9 (1) (1) (1) (2) (1) Replacing Main Burners 1) Y our Weber Gas Barbecue must be OFF and cool. 2) Turn gas OFF at source. 3) T o remove control panel: take off the burner control knobs. Remove the screws holding the control panel in place. Lift off the control panel.
D-10 Cr osso ver® Ignition System Operations If the Crossover Ignition System fails to ignite the Left burner , light the Left burner with a match. If the Left burner lights with a match, then check the Crossover Ignition System. ■ Check that both the white(1) and black(2) ignition wires are attached properly .
T r oubleshooting Pr oblem Chec k Cure Burners b urn with a yello w or orange flame, in conjunction with the smell of gas. Inspect Weber Spider Stopper Guards for possible obstructions. (Blockage of holes.) Clean Weber Spider Stopper Guards. (See Section “Annual Maintenance”) Burners do not light.
An important point after buying a device Weber Weber Liquid Propane Gas (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Weber Weber Liquid Propane Gas yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Weber Weber Liquid Propane Gas - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Weber Weber Liquid Propane Gas you will learn all the available features of the product, as well as information on its operation. The information that you get Weber Weber Liquid Propane Gas will certainly help you make a decision on the purchase.
If you already are a holder of Weber Weber Liquid Propane Gas, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Weber Weber Liquid Propane Gas.
However, one of the most important roles played by the user manual is to help in solving problems with Weber Weber Liquid Propane Gas. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Weber Weber Liquid Propane Gas along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
