Instruction/ maintenance manual of the product CC12 Xantech
Go to page of 4
1 Remote Control Switchers INST ALLA TION INSTRUCTIONS CC12 REMOTE RELAY MODULE The CC12, Fig. 1 , is an IR Remote Controlled Double Pole Double Throw Relay Module. It provides dry contact closures to satisfy a variety of uses, such as activation of screen drops, projector lifts, etc.
2 CC12 5 OFF ON TGL MMT OFF ON TGL MMT OFF ON TGL MMT OFF ON TGL MMT OFF ON TGL MMT OFF ON TGL MMT OFF ON TGL MMT OFF ON TGL MMT B 0 2 3 4 5 6 1 7 80 48 10 90 01 00 C0 50 D0 41 40 A0 30 B0 21 20 E.
3 Remote Control Switchers CC12 0 1 2 3 4 5 6 7 N/C N/O N/O N/C 1 2 IR CONFIRM CODE SUB- GROUP OFF = N/C ON = N/O CC12 REMOTE RELAY MODULE IR IN CI GND +12VDC PROJECTION SCREEN CONTROLLER MOMENT A.
4 • Note that, as in Fig. 3 , the N/O (normally open) contacts are connected to the screen and projector lift's MOMENTARY terminals. This allows the momentary action to occur. • As a practical matter, it will be necessary to see that the projector and the screen positions are both UP prior to the issuance of the first command.
An important point after buying a device Xantech CC12 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Xantech CC12 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Xantech CC12 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Xantech CC12 you will learn all the available features of the product, as well as information on its operation. The information that you get Xantech CC12 will certainly help you make a decision on the purchase.
If you already are a holder of Xantech CC12, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Xantech CC12.
However, one of the most important roles played by the user manual is to help in solving problems with Xantech CC12. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Xantech CC12 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
