Instruction/ maintenance manual of the product RT16-10 Xantech
Go to page of 6
1 Remote Control Switchers Fig. 2 ID Code Switch INST ALLA TION INSTRUCTIONS RT16-10 ADDRESSABLE INFRARED ROUTER The RT16-10 is a ONE-IN/SIXTEEN-OUT IR switcher which directs an infrared control signal to any one of 16 output ports, any combination of ports, or all 16 as a group.
2 1 2 3 4 5 6 ON 0 Controller & Address Switches ON (1) OFF (0) RC68 PROGRAMMER / REMOTE CONTROL The RC68+ (or RC68) Programmer (available separately) contains all the commands necessary to operate the RT16-10 (see Fig.
3 Remote Control Switchers 1 2 3 4 5 6 ON 1 Controller & Address Switches ON (1) OFF (0) Factory Installed Jumper IR Receiver Input Connector on RT16-10 IR RCVR INPUT +12 G G S S Fig.
4 INSTALLATION Fig. 5 illustrates a typical application where an RT16-10 is used to route IR control signals to 15 TV monitors. 1. For this example, it is assumed that Single Routing with Group ON and OFF is required. 2. Since only one RT16-10 is used in the system, the factory preset Code Group 70 can be used.
5 Remote Control Switchers +12 VDC IR OUT GND 780-10 J-BOX RECEIVER 283M 283M Blink-IR™ Mouse Emitter T o Emitters on even numbered TV's +12V IR OUT GND Use additional Control Devices as needed.
6 11-7-00 RF/IR RF IR CPL10 RF/IR RF IR CPL10 RF/IR RF IR CPL10 RF/IR RF IR CPL10 RF/IR RF IR CPL10 RF/IR RF IR CPL10 RF/IR RF IR CPL10 RF/IR RF IR CPL10 CPL10 Coupler (30 locations) 6015900 3.
An important point after buying a device Xantech RT16-10 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Xantech RT16-10 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Xantech RT16-10 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Xantech RT16-10 you will learn all the available features of the product, as well as information on its operation. The information that you get Xantech RT16-10 will certainly help you make a decision on the purchase.
If you already are a holder of Xantech RT16-10, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Xantech RT16-10.
However, one of the most important roles played by the user manual is to help in solving problems with Xantech RT16-10. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Xantech RT16-10 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
