Instruction/ maintenance manual of the product BC25EB Black & Decker
Go to page of 12
25 AMP SMAR T ™ FULL Y A UT OMA TIC B A TTER Y CHARGER INSTR UCTION MANU AL Thank you for choosing Black & Decker! Go to www .BlackandDecker .com/NewOwner to register your new product Catalog Nu.
1 GENERAL SAFETY WARNINGS AND INSTRUCTIONS FOR ALL APPLIANCES READ ALL INSTRUCTIONS READ ALL INSTRUCTIONS WARNING: Read all instructions before operating product. Failure to follow all instructions listed below may result in electric shock, fire and/or serious injury .
2 SAFETY GUIDELINES / DEFINITIONS DANGER: Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury . WARNING: Indicates a potentially hazardous situation which, if not avoided, could result in death or serious injury .
3 • Have plenty of fresh water and soap nearby in case battery acid contacts skin. • If battery acid contacts skin or clothing, wash immediately with soap and water for at least 10 minutes and get medical attention immediately . • Never smoke or allow a spark or flame in vicinity of vehicle battery , engine or charger .
4 DC Connection Precautions 1. Connect and disconnect DC output clamps only after removing AC cord from electric outlet. 2. Never allow clamps to touch each other . 3. Attach clamps to battery and chassis as indicated in “Batter y Installed in Vehicle” steps 5 and 6, and in “Battery Outside of Vehicle” steps 2, 4 and 5.
5 that ensures fast, safe and complete charging of serviceable batteries. S tage One — Rapid Start Charge at 25 amps delivers maximum charging amperage to “wake up” any serviceable 12 volt battery and allows for quick engine starting.
6 Battery Type (Step 1) allows the user to select Wet, Gel or AGM type of battery for efficient and safe charge. Most automotive batteries are Wet batteries. Refer to the battery manufacturer’ s specifications for batter y type. 2/10/25A AMP (Charge Rate Selector) (Step 2) allows the user to select the charge rate based on battery size.
7 Instructions” section of this manual. Charge Rate Selection After charger clamps are correctly connected, plug in the charger to a 120 volt AC outlet. The charger will show a “000” on the Digital Display , indicating power has been applied. Select the proper charge current rate based on battery size.
8 WARNING: BURST HAZARD: • NEVER EQUALIZE A GEL OR AGM BATTERY, these may burst and cause SERIOUS INJURY and property damage. • Remove or disconnect the vehicle’ s batter y when equalizing. The frequency which the equalization process needs to be run depends on the use of the battery .
9 1. Make sure the charger is in initiation state with a circulating pattern on the display or in charge OFF mode with “000” on the display . If not, press 2/10/25 AMP button repeatedly until “000” shows on the display . 2. Press the Battery Recondition button to start the process.
10 F02 — Bad Battery Connection or Battery Voltage Too Low to Accept Charge When F02 appears, the most common cause is poor connection to battery . • Follow the steps outlined in “Important Safety Instructions” at the front of this manual to disconnect AC cord and clamps, clean battery terminal and reconnect.
11 contact the Black & Decker location nearest you. T o find your local service location, refer to the yellow page directory under "T ools—Electric" or call: 1-800-544-6986 or visit www.blackanddecker .com. FULL FIVE-YEAR HOME USE W ARRANTY Black & Decker (U.
An important point after buying a device Black & Decker BC25EB (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Black & Decker BC25EB yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Black & Decker BC25EB - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Black & Decker BC25EB you will learn all the available features of the product, as well as information on its operation. The information that you get Black & Decker BC25EB will certainly help you make a decision on the purchase.
If you already are a holder of Black & Decker BC25EB, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Black & Decker BC25EB.
However, one of the most important roles played by the user manual is to help in solving problems with Black & Decker BC25EB. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Black & Decker BC25EB along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
