Instruction/ maintenance manual of the product EBSTNM-2 Lennox Hearth
Go to page of 24
1 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. HOMEOWNER'S CARE AND OPERA TION INSTRUCTIONS MODELS RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE FOR YOUR SAFETY: Do not store or use gasoline or other flammable vapors or liquids in the vicin- ity of this or any other appliance.
2 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. These appliances are designed to operate on natural or propane gas only. Input of millivolt models is shown in the fol- lowing table: CONGRATULATIONS! In selecting this LENNOX B-Vented Gas Appliance you have chosen the finest and most dependable fireplace to be found anywhere.
3 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. Carbon Monoxide Poisoning: Early signs of carbon monoxide poisoning are similar to the flu with headaches, dizziness and/or nausea.
4 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. Figure 2 Note: The piezo ignitor is located on the modesty panel - see Figure 1. Remove the modesty panel carefully, so that none of the wires become loose or discon- nected. Now complete access to the gas con- trol valve and its related controls is attainable.
5 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. Outside Combustion Air Controls Many appliances are equipped, when installed, with an outside (make-up air) vent system that is designed to provide the appliance with outside make-up air for combustion when in operation.
6 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. Manual-Reset Safety Limit Switch This appliance is equipped with a manual- reset blocked flue safety limit switch.
7 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. Periodically (After the Burning Season) Maintenance Task Accomplishing Person Procedure Cleaning Firebox Interior Check Flame Patterns and Flame Heig.
8 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. Refer to Figure 6 and remove the front glass enclosure panel as follows: 1. Remove the top bustle, and the top louver assembly or radiant panel. Then remove the bottom bustle. 2. Open the control compartment access panel.
9 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. Log Placement WARNING: LOG SET GETS VERY HOT AND WILL REMAIN HOT UP TO ONE HOUR AFTER GAS SUPPLY IS TURNED OFF. HANDLE ONLY WHEN LOG SET IS COOL. TURN OFF ALL GAS TO THE APPLIANCE BEFORE INSTALLING THE GRATE AND LOG SET.
10 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. Electronic Appliance Checkout To light the burner, refer to the lighting instruc- tions on page 15 and 16 . Ensure the ignitor lights the pilot. The pilot flame should engulf the flame sensor as shown in Figure 12 .
11 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. Arch Door Kits Two types of arch door kits are available for the Multi-Open Series. Both types of kits are easy to install and do not require hardware to attach them to the standard door frame. These kits can be retrofitted to previously installed Multi-Open Series appliances.
12 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. Polished Brass and Brushed Stainless Hood Kits Attractive hoods are available in two styles to be used on the Multi-Open Series appliances. These hoods are designed to be fitted to the glass viewing sides of the appliance.
13 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. ACCESSORY COMPONENTS CONTINUED Polished Brass and Brushed Stainless Louvers Kits Decorative louvers are available for use with all Multi-Open Series appliances. These louvers are designed to replace the standard radiant panels that are provided with the appliance.
14 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. LIGHTING INSTRUCTIONS – MILLIVOLT GAS VALVE WARNING: IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSION MAY RESULT CAUSING PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE. FOR YOUR SAFETY READ BEFORE LIGHTING A.
15 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. INSTRUCTIONS D’ALLUMAGE – VANNE GAZ MILLIVOLT INSTRUCTIONS D'ALLUMAGE AVERTISSEMENT : SI VOUS NE SUIVEZ PAS CES INSTRUCTIONS À LA LETTRE, IL POURRAIT S’EN SUIVRE UN INCENDIE OU UNE EXPLOSION CAUSANT DES DOMMAGES MATÉRIELS, DES BLESSURES CORPORELLES OU MÊME DES PERTES DE VIE.
16 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. WARNING: IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSION MAY RESULT CAUSING PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE. A. When lighting the appliance, follow these instructions exactly.
17 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. INSTRUCTIONS D’ALLUMAGE — ELECTRONIC INSTRUCTIONS D’ALLUMAGE POUR VOTRE SÉCURITÉ, LISEZ CES INSTRUCTIONS AVANT L’ALLUMAGE A. Lorsque vous allumez l ’ appareil, suivez exactement ces instruc- tions.
18 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. TROUBLESHOOTING THE MILLIVOL T GAS CONTROL SYSTEM 1. Spark ignitor will not light pilot after repeated triggering of ignitor button. 2. Pilot will not stay lit after carefully following the lighting instructions.
19 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. TROUBLESHOOTING THE ELECTRONIC IGNITION SYSTEM SYMPTOM POSSIBLE CAUSES CORRECTIVE ACTION See Below. Disconnect the two black wires from the wire nuts. Test switch(s) for continuity with a multimeter.
20 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. REPLACEMENT PARTS GAS CONTROLS — HONEYWELL ELECTRONIC GAS CONTROLS — SIT MILLIVOLT GAS ORIFICES — SIT AND HONEYWELL SYSTEMS . o NN O I T P I R C S E D l a r u t a Ne n a p o r P . o N t r a P. y t Q.
21 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. REPLACEMENT PARTS LIST . o NN O I T P I R C S E D e n a p o r P d n a l a r u t a N . o N t r a P. y t Q. y t Q. y t Q. y t Q. y t Q 2 - T S B E2 - F P B E2 - L C B E2 - R C B EY A B B E a 1. n i 4 2 - l a o c r a h c , t n a i d a R r e p p UY E 5 8 8 1 9 - B Le n o n 1 112 b 1.
22 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. REPLACEMENT PARTS 2b 4b 5b 6b 1b 3b 42 7 15 11a 11b 17 16 31 13a 37 43 41 45 32 33 44 40 14 15 13b 35 36 50 51 30 12 12 Front Burner Rear Burner Note: - EBPF-2 Shown - see the tables on pages 20 and 21 for replacement parts applicable to EBST -2, EBCR-2, EBCL-2 and EBBA Y fireplaces.
23 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. NOTES:.
24 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. Printed in U.S.A. © 2002 by LENNOX HEARTH PRODUCTS P/N 875,012M REV. D 05/2004 Lennox Hearth Products reserves the right to make changes at any time, without notice, in design, materials, specifications, prices and also to discontinue colors, styles and products.
An important point after buying a device Lennox Hearth EBSTNM-2 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Lennox Hearth EBSTNM-2 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Lennox Hearth EBSTNM-2 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Lennox Hearth EBSTNM-2 you will learn all the available features of the product, as well as information on its operation. The information that you get Lennox Hearth EBSTNM-2 will certainly help you make a decision on the purchase.
If you already are a holder of Lennox Hearth EBSTNM-2, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Lennox Hearth EBSTNM-2.
However, one of the most important roles played by the user manual is to help in solving problems with Lennox Hearth EBSTNM-2. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Lennox Hearth EBSTNM-2 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
