Instruction/ maintenance manual of the product HDV500NV/PV Monessen Hearth
Go to page of 64
Installation and Operating Instructions 56D3048 9/09 Rev .
HD V Series Direct V ent Gas F ireplace 56D3048 .
56D3048 3 HD V Series Direct V ent Gas F ireplace 4. Never install the fireplace • in a recreational vehicle • where curtains, furniture, clothing, or other flam- mable objects are less than 4" from the front, top, or sides of the fireplace • in high traffic areas • in windy or drafty areas 5.
HD V Series Direct V ent Gas F ireplace 4 56D3048 14. Do not use any solid fuels (wood, coal, paper , card- board, etc.
56D3048 5 HD V Series Direct V ent Gas F ireplace • This appliance has been certified for use with either natural or propane gas. See appropriate data plates. • This appliance is not for use with solid fuels.
HD V Series Direct V ent Gas F ireplace 6 56D3048 41” (1041 mm) 46 6QE ” (1 176 mm) 42 (6QE ” .
56D3048 7 HD V Series Direct V ent Gas F ireplace Read this homeowner manual thoroughly and follow all instructions carefully .
HD V Series Direct V ent Gas F ireplace 8 56D3048 Plan for the installation of your appliance.
56D3048 9 HD V Series Direct V ent Gas F ireplace 12" Maximum Depth 12" Minimum 72" Minimum Minimum 6" From Both Side W alls FP2281 wall clg clear Ce.
HD V Series Direct V ent Gas F ireplace 10 56D3048 The fireplace must be secur ed to the floor and/or to framing studs as shown in Figure 6 . Use two () wood screws or masonry/ concrete screws to secure fireplace to the floor . Use four (4) screws to attach fireplace to framing.
56D3048 1 1 HD V Series Direct V ent Gas F ireplace The appliance is shipped as a rear vent unit.
HD V Series Direct V ent Gas F ireplace 1 56D3048 .
56D3048 13 HD V Series Direct V ent Gas F ireplace FP2465 vent clearance *3” Min. **1” Min. 1” Min. *3” Min. **1” Min. 1” Min. 48 56M ” (1226 mm) 34 6 ” (880 mm) * A Minimum of 3" Clearance to the T op Is Required Along Horizontal Length until Flue Pipe Penetrates Outside W all.
HD V Series Direct V ent Gas F ireplace 14 56D3048 There are two .
56D3048 15 HD V Series Direct V ent Gas F ireplace V V V V V V V V D L E B C F B B B B B M I A A J H G A Operable Fixed Closed Fixed Closed Opera- ble K A A A G .
HD V Series Direct V ent Gas F ireplace 16 56D3048 40 38 36 34 32 30 28 26 24 22 20 18 16 14 12 10 8 6 4 2 2 4 6 8 10 12 14 16 18 20 eg: A FP2248 sidewall vent gr aph .
56D3048 17 HD V Series Direct V ent Gas F ireplace .
HD V Series Direct V ent Gas F ireplace 18 56D3048 HOT FP1955 horizontal ven t cap Figure 17 - Install Horizontal V en.
56D3048 19 HD V Series Direct V ent Gas F ireplace .
HD V Series Direct V ent Gas F ireplace 0 56D3048 • The maximum number of 45° elbows perm itted per sid e wal l inst all ati on is two (). These elb ows can be inst all ed in either the vertical or horizontal run.
56D3048 1 HD V Series Direct V ent Gas F ireplace .
HD V Series Direct V ent Gas F ireplace 56D3048 If the fou nda ti on is rece sse d, use recess brackets (not supplied) for securing lower portion of the snorkel. Fasten brackets to wall first, then secure to snorkel with self drilling # 8 x 1 / s h e e t metal screws.
56D3048 3 HD V Series Direct V ent Gas F ireplace • The maximum angular variation allowed in the system is 70°. Figure 31 • The minimum heig ht of the vent above the highest point of penetration through the roof is 1' (305 mm).
HD V Series Direct V ent Gas F ireplace 4 56D3048 If an of fset is needed to avoid obstructions, you must support the vent pipe every three (3) feet. Use wall straps for this purpose .
56D3048 5 HD V Series Direct V ent Gas F ireplace FP1972 appliance connection UL1777 Flex V ent Screws (3 places, equid.
HD V Series Direct V ent Gas F ireplace 6 56D3048 T ermination Cap Storm Collar Roof Sup- port Flashing Rigid Pipe Length Flex to Pipe Adapter Firestop UL1777 Flex PIpe DVF A/8 Adapter Figure 38 - .
56D3048 7 HD V Series Direct V ent Gas F ireplace Use proper gas type for the fireplace you are installing. If you have conflicting gas type, do not install fire- place.
HD V Series Direct V ent Gas F ireplace 8 56D3048 The gas line connection may be made using 1/" rigid tubing or an approved flex connector . Sinc e some munici pali tie s have add itio nal local cod es it is alway s best to consu lt you r local author iti es and the current edition of the National Fuel Gas Code ANSI.
56D3048 9 HD V Series Direct V ent Gas F ireplace 1. Check gas type. The gas suppl y must be the sa me as stated on the appliance’s rating decal.
HD V Series Direct V ent Gas F ireplace 30 56D3048 ON OFF OPTIONAL REMOTE W ALL SWITCH ON OFF OPTIONAL REMOTE W ALL SWITCH PILOT HI LO ON OFF TH TP TH/TP ON OFF RS FP2469 HDV wiring .
56D3048 31 HD V Series Direct V ent Gas F ireplace This appliance is equipped with a pilot which must be lit with built-in ignitor while following these instructions exactly . BEFORE OPERA TING smell all around the appliance area for gas.
HD V Series Direct V ent Gas F ireplace 3 56D3048 Y ou may check for gas leaks with the following methods onl.
56D3048 33 HD V Series Direct V ent Gas F ireplace O F F P I L O T O N PILOT FP1937 control knob on The “ON/OFF/RS” switch for the main burner can be found behind door of the fireplace. This switch allows you to turn on and to turn off the main burner without using the gas valve knob.
HD V Series Direct V ent Gas F ireplace 34 56D3048 1. Check gas type. The gas supply must be the same as stated on the appliance’s rating decal. If the gas supply is dif ferent from the fireplace, Do not install the appliance. Contact your dealer immediately .
56D3048 35 HD V Series Direct V ent Gas F ireplace COMMAND CENTER 4-AA BA TTERY COMP ARTMENT MASTER SWTICH TO JUNCTION BOX IN FIREPLACE CONVERSION NG/LP RF RECEIVER ON/OFF BUTTON WHITE BLACK WHITE BLA.
HD V Series Direct V ent Gas F ireplace 36 56D3048 Dual Blowers (300 W Max) To Junction Box In Fireplace WHITE BLACK WHITE BLACK BLACK WHITE GREEN Connector Pin To Contro l Box { { Optional Light Opti.
56D3048 37 HD V Series Direct V ent Gas F ireplace This appliance is equipped with an ignition device which automatically lights the pilot.
HD V Series Direct V ent Gas F ireplace 38 56D3048 1.
56D3048 39 HD V Series Direct V ent Gas F ireplace FP191.
HD V Series Direct V ent Gas F ireplace 40 56D3048 System configuration/setup is done on the Command Center .
56D3048 41 HD V Series Direct V ent Gas F ireplace .
HD V Series Direct V ent Gas F ireplace 4 56D3048 Remove top louver assembly before installing canopy . 1. Unhook top louver assembly . Set aside. Figure 55 . Attach canopy to underside of top outer shell with three (3) screws provided.
56D3048 43 HD V Series Direct V ent Gas F ireplace Install floor brick before installing logs or rock wool.
HD V Series Direct V ent Gas F ireplace 44 56D3048 4. Place bottom right log (#3) on two pins against right side of firebox. Figure 60 L G687 HDV bottom right log Bottom Right Log, #3 LG687 Figure 60 - Place Bottom Right Log L G688 HDV rear log Rear Log #1 LG688 Figure 61 - Place Rear Log 5 .
56D3048 45 HD V Series Direct V ent Gas F ireplace 7. Place right mid log (#7) on two right pins on burner assembly .
HD V Series Direct V ent Gas F ireplace 46 56D3048 L G693 HDV log final position Air Space Rock Wool LG693 Figure 66 - All Logs on Burner with Rock Wool 1.Cover any exposed burner surface with rock wool.
56D3048 47 HD V Series Direct V ent Gas F ireplace .
HD V Series Direct V ent Gas F ireplace 48 56D3048 The fireplace and venting system should be inspected before initial use and at least annually by a qualified field service person.
56D3048 49 HD V Series Direct V ent Gas F ireplace 1.
HD V Series Direct V ent Gas F ireplace 50 56D3048 4.
56D3048 51 HD V Series Direct V ent Gas F ireplace OPERA TION Install batteries and/or plug in the AC board Flip the master switch (rocker switch) to the .
HD V Series Direct V ent Gas F ireplace 5 56D3048 1 5 10 3 2 4 6 9 8 13 7 12 1 1 1 1 563048 HDV firebox parts 1.
56D3048 53 HD V Series Direct V ent Gas F ireplace 1 2C 2I 2T 2 4 5 6 3a,b,c 8b 9 7 10 1 1,12,13,14,15,16 563048 HDV millivolt parts 8a .
HD V Series Direct V ent Gas F ireplace 54 56D3048 1.
56D3048 55 HD V Series Direct V ent Gas F ireplace 1 2 3 4 17 5a,b,c 6 7 9 13, 14, 15 563048 HDV SC par ts 8b 8a .
HD V Series Direct V ent Gas F ireplace 56 56D3048 1.
56D3048 57 HD V Series Direct V ent Gas F ireplace 2 3 6 7 4 1 5 8 563048 HDV logs 1.
HD V Series Direct V ent Gas F ireplace 58 56D3048 1 2 2 3 4 5 563048 HDV accessories 1.
56D3048 59 HD V Series Direct V ent Gas F ireplace HOT 1 2 3 4 5 6 9 7 8 1 1 10 563048 HDV 4 x 6 vent parts .
HD V Series Direct V ent Gas F ireplace 60 56D3048 For more information about, or instructions for, the venting components referenced above, please contact the component manufaturer: Selkirk Corporation: www .
56D3048 61 HD V Series Direct V ent Gas F ireplace.
HD V Series Direct V ent Gas F ireplace 6 56D3048 This product must be installed by a licensed plumber or gas fitter when installed within the Commonwealth of Massachusetts.
56D3048 63 HD V Series Direct V ent Gas F ireplace The following components are warranted for life to the original owner , subject to proof of pur- chase: Firebox, Combustion Chamber , Heat Exchanger , Grate and Stainless Steel Burners.
149 Cleveland Drive • Paris, Kentucky 40361 www .mhsc.com HDV500NV 69.
An important point after buying a device Monessen Hearth HDV500NV/PV (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Monessen Hearth HDV500NV/PV yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Monessen Hearth HDV500NV/PV - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Monessen Hearth HDV500NV/PV you will learn all the available features of the product, as well as information on its operation. The information that you get Monessen Hearth HDV500NV/PV will certainly help you make a decision on the purchase.
If you already are a holder of Monessen Hearth HDV500NV/PV, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Monessen Hearth HDV500NV/PV.
However, one of the most important roles played by the user manual is to help in solving problems with Monessen Hearth HDV500NV/PV. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Monessen Hearth HDV500NV/PV along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
